Considerations of Physical Design and Implementation for 5 MHz-100 W LLC Resonant DC-DC Converters
نویسندگان
چکیده
منابع مشابه
DC-DC Resonant converters with APWM control
An asymmetrical pulse width modulated (APWM) dc-dc converters operating at constant frequency was simulated using Pspice software package. This converter incorporates constant frequency operation in a basic soft switching half bridge topology without any additional component and complexity. In this paper operation of converter configuration with capacitive filter in the output is discussed. A 5...
متن کاملDesign and Implementation of Modern Digital Controller for DC-DC Converters
Several techniques are available for implementing DC-DC converters using digital controllers Among these FPGA (Field Programmable Gate Array) based implementation provides various advantages in terms of speed, flexibility, low power usage, reduced equipment sizing and massive parallelism. The traditional methods allow fault diagnosis only after the final implementation which leads to extra cost...
متن کاملDesign and Implementation of a Digital Controller For DC-to- DC Power Converters
A digital signal processor (DSP) solution is proposed to control an H-bridge DC-DC isolated output power converter. The multiple mode digital controller is evaluated with an existing Westinghouse 1-kW power stage. The digital controller was developed using the dSPACE [1] rapid prototype development system and MATLAB/Simulink. It is evaluated using a real-time digital control development platfor...
متن کاملWeA3-1 : Design Considerations for Very High Frequency dc-dc Converters
This document describes several aspects relating to the design of dc-dc converters operating at frequencies in the VHF range (30-300 MHz). Design considerations are treated in the context of a dc-dc converter operating at a switching frequency of 100 MHz. Gate drive, rectifier and control designs are explored in detail, and experimental measurements of the complete converter are presented that ...
متن کاملDesign of Automatic Fuzzy Control for Parallel DC-DC Converters
an automatic fuzzy control (AFC) system for a parallel dc-dc converter, and the control objective is to achieve the stable voltage regulation and uniform current distribution. The average model for an example of a three-module boost converter, which is composed of three conventional boost converter frames in parallel connection, is derived for the design of this AFC system including voltage and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Active and Passive Electronic Components
سال: 2016
ISSN: 0882-7516,1563-5031
DOI: 10.1155/2016/4027406