Concentric Split Aluminum with Silicon-Aluminum Nitride Annular Rings Resonators
نویسندگان
چکیده
منابع مشابه
Aluminum Nitride Piezoelectric Micromachined Ultrasound Transducer Arrays
Air-coupled piezoelectric micromachined ultrasound transducer arrays, operating at ~190 kHz, have been fabricated utilizing an aluminum nitride piezoelectric layer. Improved fabrication processes have reduced the frequency variation seen in our previous work with single transducers resulting in arrays of transducers with resonant frequencies (fn) that match within the fractional half-power band...
متن کاملAluminum Nitride Deep - ultraviolet Light - emitting
The shortest-wavelength color of light that is visible to the human eye is violet. As shown in Fig. 1, light with wavelengths shorter than 400 nm is called ultraviolet (UV) light: that from 300 to 400 nm is called near-UV light, that from 200 to 300 nm is called deep-UV light, and that shorter than 200 nm is called vacuum-UV light. Since vacuum-UV is absorbed by air, deep-UV light is the shorte...
متن کاملDesign of Piezoelectric Aluminum Nitride MEMS Resonator
The following work reports the design, numerical, analytical and simulation characterization of an Aluminum Nitride MEMS resonator. The paper offers a comparison of rectangular plate MEMS resonator (length extensional and width extensional mode shapes) and ring shape MEMS resonator. It also demonstrates the contour Eigen modes of resonators and their equivalent electric circuit model (BVD). Fur...
متن کاملExperimental Study of Fine Frequency Selection Techniques for Piezoelectric Aluminum Nitride Lamb Wave Resonators
Experimental Study of Fine Frequency Selection Techniques for Piezoelectric Aluminum Nitride Lamb Wave Resonators by Ting-Ta Yen Master of Science, Plan II in Electrical Engineering and Computer Sciences University of California, Berkeley Professor Albert P. Pisano, Chair Strong demand for high-Q resonators and filters in mobile wireless communication systems has initiated various research on r...
متن کاملResearching the Aluminum Nitride Etching Process for Application in MEMS Resonators
We investigated the aluminum nitride etching process for MEMS resonators. The process is based on Cl2/BCl3/Ar gas chemistry in inductively coupled plasma system. The hard mask of SiO2 is used. The etching rate, selectivity, sidewall angle, bottom surface roughness and microtrench are studied as a function of the gas flow rate, bias power and chamber pressure. The relations among those parameter...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Micromachines
سال: 2019
ISSN: 2072-666X
DOI: 10.3390/mi10050296