Computer simulation of low-temperature composites sintering processes for additive technologies
نویسندگان
چکیده
منابع مشابه
THE EFFECT OF COBALT ADDITIVE ON MICROSTRUCTURE AND PROPERTIES OF W-CU COMPOSITES PREPARED BY SINTERING AND INFILTRATION PROCESSES
In the present paper, the influence of cobalt additive on the sintering/infiltration behavior of W-Cu composite was studied. For this purpose, the mixed powders of tungsten and cobalt were compacted by CIP method and then sintered at 1450, 1550 and 1600 °C in a hydrogen atmosphere. The sintered specimens at 1550 °C were subsequently infiltrated with liquid copper at 1250 °C for 10, 60 and 1...
متن کاملLow Temperature Sintering Additives for Silicon Nitride
This work deals with sintering additives for the low temperature pressureless sintering of Si3N4, via a transient liquid technique. Much attention has been given to the development of a sintering process using low-cost Si3N4 powder (Silzot HQ, Germany) as the starting material and employing sintering additives which are also both economically attractive and enable sintering at low temperatures....
متن کاملWaste derived glass ceramic composites prepared by low temperature sintering/sinter-crystallisation
Waste derived glass ceramic composites prepared by low temperature sintering/sinter-crystallisation I. Ponsot, R. Detsch, A. R. Boccaccini & E. Bernardo To cite this article: I. Ponsot, R. Detsch, A. R. Boccaccini & E. Bernardo (2015) Waste derived glass ceramic composites prepared by low temperature sintering/sinter-crystallisation, Advances in Applied Ceramics, 114:sup1, S17-S25, DOI: 10.1179...
متن کاملNumerical Simulation of Temperature Field in Selective Laser Sintering
The laser sintering process of multi-component powder W/Cu is simulated by ANSYS software based on the factors of radiation, convection and thermal physical parameters on temperature. The laser power and scanning velocity which are the key process parameters to affect directly in sintering molding are studied in paper. The results show that when the scanning velocity is constant, the sintering ...
متن کاملComposites Manufacturing Processes: Towards an Advanced Simulation
HAL is a multi-disciplinary open access archive for the deposit and dissemination of scientific research documents, whether they are published or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers. L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2017
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/286/1/012001