Computer Simulation of Drying Stresses in Wood

A Method of Calculating Internal Stresses in Drying Wood

Simulation of Stresses Induced by Heat and Mass Transfer in Drying Process of Clay-like Material

Drying represents one of the oldest unit operations employed in industrial processes. Drying is viewed as a process of simultaneous heat and mass transfer. Porous Clay-like material undergoes stresses due to non-uniform distribution of temperature and moisture induced by heat and mass transfer respectively. The aim of this work is to simulate the stresses induced by heat and mass transfer durin...

Microwave Drying of Wood Strands

Characteristics of microwave drying of wood strands with different initial moisture contents and geometries were investigated using a commercial 10 small microwave oven under different power inputs. Temperature and moisture changes along with the drying efficiency were examined at different drying scenar­ ios. Extractives were analyzed using gas chromatography=mass spectrometry (GC=MS). The res...

Drying patterns: Sensitivity to residual stresses.

Volume alteration in solid materials is a common cause of material failure. Here we investigate the crack formation in thin elastic layers attached to a substrate. We show that small variations in the volume contraction and substrate restraint can produce widely different crack patterns ranging from spirals to complex hierarchical networks. The networks are formed when there is no prevailing gr...

Spectroscopic studies of wood-drying processes.

By the use of wavelength-modulation diode laser spectroscopy, water vapor and oxygen are detected in scattering media nonintrusively, at 980 nm and 760 nm, respectively. The technique demonstrated is based on the fact that free gases have extremely sharp absorption structures in comparison with the broad features of bulk material. Water vapor and oxygen measurements have been performed during t...