Computational fluid dynamics simulation of subcooled flow boiling in vertical rectangular 2-mm narrow channel
نویسندگان
چکیده
منابع مشابه
Critical heat flux in subcooled flow boiling of fluorocarbon liquid on a simulated electronic chip in a vertical rectangular channel
Experiments are performed to correlate and model CHF during subcooled flow boiling of dielectric fluoro~rbon (FC-72) liquid on a smooth 12.7 x 12.7 mm* sirn~at~ electronic chip inside a vertical rectangular channel. Two distinct CHF regimes are established based on flow visualization and experimental data. At low flow velocities, CHF is accompanied by the formation of a continuous vapor blanket...
متن کاملModeling of Upward Subcooled Flow Boiling of Refrigerant-113 in a Vertical Annulus
In this paper, a modified two-fluid model has been adopted to simulate the process of upward vertical subcooled flow boiling of refrigerant R-113 in a vertical annular channel at low pressure. The modified model considers temperature dependent properties and saturation temperature variation and was validated against a number of published low-pressure subcooled boiling experiments. The results s...
متن کاملMultiphase flow and tromp curve simulation of dense medium cyclones using Computational Fluid Dynamics
Dense Medium Cyclone is a high capacity device that is widely used in coal preparation. It is simple in design but the swirling turbulent flow, the presence of medium and coal with different density and size fraction and the presence of the air-core make the flow pattern in DMCs complex. In this article the flow pattern simulation of DMC is performed with computational fluid dynamics and Fluent...
متن کاملapplication of computational fluid dynamics for modeling of secondary flow cells in trapezoidal channel
channel flows have three components of velocity, 1component in flow direction and 2components in spanwise of channel. because of heterogeneity of velocity undulations, in the channel section the vortices are formed that are nominated “secondary current cells”. these cells cause the lateral shear stress in the channel walls and introduce the erosion and scour of the channel walls. heterogeneity ...
متن کاملSimulation of Boiling in a Vertical Channel Using Ensemble Average Model
Simulation of turbulence boiling, generation of vapour and predication of its behaviour are still subject to debate in the two-phase flow area and they receive a high level of worldwide attention. In this study, a new arrangement of the three dimensional governing equations for turbulence two-phase flow with heat and mass transfer are derived by using ensemble averaging two-fluid model and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2015
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814015594349