Computational fluid dynamic model for machining using minimum quantity coolant
نویسندگان
چکیده
منابع مشابه
Machining Using Minimum Quantity Lubrication: A Technology for Sustainability
The purpose of this article is to review the relevant literature in machining using minimum quantity lubrication particularly as it pertains to environmental, and health issues , and outline future potential research in this technology. The results indicate that the process of mist particles generation and their physical characteristics are yet to be determined for a whole class of machining pr...
متن کاملStudy the Effects of Nano Fluid as a Coolant in Milling Process for Improving Machining Parameters
The aim of this research work is to evaluate the effects of coolant including nano- powder material for the cooling purpose in milling process and comparing the results with the conventional coolant. Generation heat and weak heat transfer reduces the tool life and also deteriorate surface roughness during milling operation. To overcome this problem, it is necessary to use coolant for cooling as...
متن کاملMinimum Quantity Lubrication (MQL) in Machining: Benefits and Drawbacks
Micro lubrication or also known as minimum quantity lubrication (MQL) serves as an alternative to flood cooling by reducing the volume of cutting fluid used in the machining process; but not without significant health concerns. Flood cooling is primarily used to cool and lubricate the cutting tool and work piece interface during machining process. The adverse health effects caused by the use of...
متن کاملComputational Fluid Dynamic- Two Fluid Model Study of Gas-Solid Heat Transfer in a Riser with Various Inclination Angles
A two fluid model (TFM) was used to study gas-solid heat transfer in a riser with different inclination angles. A two dimensional pipe with 5.8 cm internal diameter and 5 meter length was chosen. Effect of bed angle and solid particles feed rate were studied on the heat transfer behavior of gas and solid particles. Obtained results from simulation are compared with the experimental data in the...
متن کاملDynamic Machining Project Control Model under Order Quantity and Deadline Constraints
To achieve the optimal control of material removal rate (MRR) for a machining project, a Dynamic Machining Project Control (DMPC) Model is proposed under the considerations of order quantity and deadline constraints. This paper not only introduces material removal rate into the objective function dynamically, but also implements Calculus of Variations to resolve the continuous control problem c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2020
ISSN: 1757-899X
DOI: 10.1088/1757-899x/973/1/012048