COMPUTATION METHOD WITH NODAL LOAD EQUIVALENT TO CREEP STRAIN
نویسندگان
چکیده
منابع مشابه
A Parallel Probabilistic Load Flow Method Considering Nodal Correlations
Jun Liu 1, Xudong Hao 1, Peifen Cheng 1, Wanliang Fang 1,* and Shuanbao Niu 2 1 Shaanxi Key Laboratory of Smart Grid, State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an 710049, China; [email protected] (J.L.); [email protected] (X.H.); [email protected] (P.C.) 2 Northwest Subsection of...
متن کاملCreep and Creep Recovery Response of Load Cells Tested According to U.S. and International Evaluation Procedures
The 60 min creep data from National Type Evaluation Procedure (NTEP) tests performed at the National Institute of Standards and Technology (NIST) on 65 load cells have been analyzed in order to compare their creep and creep recovery responses, and to compare the 60 min creep with creep over shorter time periods. To facilitate this comparison the data were fitted to a multiple-term exponential e...
متن کاملInvestigation of indentation derived creep response using constant load and constant strain rate methods
Time dependent plastic deformation in metals can occur at high temperatures. Typically the creep test is conducted to characterize the deformation features; however, the conventional uniaxial power-law creep test may be impractical for small scale materials. Accordingly, instrumented indentation techniques are frequently employed. This study concerns the employment of instrumented indentation t...
متن کاملEstimating the creep strain to failure of PP at different load levels based on short term tests and Weibull characterization
The short and long term creep behavior is one of the most important properties of polymers used for engineering applications. In order to study this kind of behavior of PP tensile and short term creep measurements were performed and analyzed using long term creep behavior estimating method based on short term tensile and creep tests performed at room temperature, viscoelastic behavior, and vari...
متن کاملLattice strain evolution and load partitioning during creep of a Ni-based superalloy single crystal with rafted microstructure
In-situ neutron diffraction measurements were performed on monocrystalline samples of the Ni-based superalloy CMSX-4 during N-type g0 raft formation under the tensile creep conditions of 1150 C/ 100 MPa, and subsequently on a rafted sample under the low temperature/high stress creep conditions of 715 C/825 MPa. During 1150 C/100 MPa creep, the g0 volume fraction decreased from ~70% to ~50%, the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshu
سال: 1995
ISSN: 0289-7806,1882-7187
DOI: 10.2208/jscej.1995.516_105