Composite structure test facility in Natl. Aerospace Lab..
نویسندگان
چکیده
منابع مشابه
The French Aerospace Lab
This paper first gives an introduction to the broad features of the Darwin mission of ESA and then describes in some detail the data processing that is necessary to detect planets and spectrally characterize them. The proposed data processing method is validated by means of simulated data. in Astronomy with High Contrast Imaging III, EAS Publications Series, EDP Sciences, Les Ulis, France, 2006.
متن کاملGerman-Lab Experimental Facility
The G-Lab project aims to investigate concepts and technologies for future networks in a practical manner. Thus G-Lab consists of two major fields of activities: research studies of future network components and the design and setup of experimental facilities. Both is controlled by the same community to ensure, that the experimental facility fits to the demand of researchers. Researchers gain a...
متن کاملVibration Characteristics of an Aps Lab Facility
The vibratory behavior of a lab facility located in Building 401 of the Advanced Photon Source site at Argonne National Laboratory is summarized. Measurements of ambient vibration indicate that acceptable displacement levels are usually maintained (rms value below 0.1 microns) for the measured frequency range, above 0.2 Hz. An exception occurs when strong wind conditions excite a horizontal bui...
متن کاملVacuum Laser Acceleration Experiment Perspective at Brookhaven National Lab-accelerator Test Facility
This first stage experiment is a Proof-of-Principle to support our novel vacuum laser acceleration (VLA) theory, published previously. Simulations show that based on current experimental conditions at the Brookhaven National Laboratory Accelerator Test Facility (ATF), an electron beam with initial energy of 15 MeV can get net energy gain from an intense CO2 laser beam. The difference of electro...
متن کامل1985 NF Test Facility
Near-field ranges operate by measuring the electromagnetic field near the antenna and then mathematically transforming the data to any arbitrary location. Near-field operations are a form of microwave holography. The wave front measurements are normally made on a planar, spherical or cylindrical surface. This paper discusses primarily the planar configurations as used in the measurement of larg...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Composite Materials
سال: 1992
ISSN: 0385-2563
DOI: 10.6089/jscm.18.33