Complementary Ligts for Power IC Applications
نویسندگان
چکیده
منابع مشابه
Flexible Power Electronic Transformer for Power Flow Control Applications
This paper proposes a Flexible Power Electronic Transformer (FPET) for the application in the micro-grids. The low frequency transformer is usually used at the Point of Common Coupling (PCC) to connect the low voltage grid and utility network to each other. The conventional 50Hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. In this pap...
متن کاملTB332: An Integrated Synchronous-Rectifier Power IC with Complementary-Switching (HIP5010, HIP5011)
A new partitioning approach integrates the power devices and drive of a high-efficiency synchronous-rectified buck converter for numerous advantages in low-voltage power systems. This approach, coupled with a low-cost voltage-mode controller, improves efficiency by eliminating the dissipative current-sensing resistor and reduces size with a smaller inductor. The resulting converter responds fas...
متن کاملGlitch Power Reduction for Low Power IC Design
Because of the rapid growth of portable electronics, high density integrated circuits with low energy consumption and low electromagnetic interference (EMI) at high speeds are needed. It is well known that dynamic power dissipation is directly related to the number of the signal transitions in the circuit. Functional signal transitions are desirable, where spurious transitions (or glitches), ca...
متن کاملflexible power electronic transformer for power flow control applications
this paper proposes a flexible power electronic transformer (fpet) for the application in the micro-grids. the low frequency transformer is usually used at the point of common coupling (pcc) to connect the low voltage grid and utility network to each other. the conventional 50hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. in this pap...
متن کاملUcc3912 Integrated Electronic Circuit Breaker Ic for Hot-swap and Power Management Applications
Today’s design engineers are faced with a variety of choices when selecting protection devices to meet their circuit or system’s design requirements. Fuses, positive temperature coefficient (PTC) resistors, and electromechanical circuit breakers represent only a sampling of the technologies available to meet their needs. Each of these devices provides a different degree of security, ranging fro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Proceedings Volumes
سال: 1987
ISSN: 0161-6374,2576-1579
DOI: 10.1149/198713.0280pv