Comparison of Vacuum Sintered and Selective Laser Melted Steel AISI 316L

Biomaterial Studies on AISI 316L Stainless Steel after Magnetoelectropolishing

The polarisation characteristics of the electropolishing process in a magnetic field (MEP – magnetoelectropolishing), in comparison with those obtained under standard/conventional process (EP) conditions, have been obtained. The occurrence of an EP plateau has been observed in view of the optimization of MEP process. Up-to-date stainless steel surface studies always indicated some amount of fre...

Micro abrasion-corrosion of AISI 316L stainless steel

In this study, the synergistic effects of abrasion and corrosion on AISI 316L stainless steel have been investigated using a micro-abrasion test rig. A series of results from abrasioncorrosion tests conducted using the micro-abrasion rig are presented. AISI 316L stainless steel has been studied under both pure abrasion and abrasion-corrosion conditions simulated by either distilled water or 3.5...

Process Mapping of Laser Glazing Aisi 316l Stainless Steel for Biomedical Implants

Optimization of Operating Parameters for Autogenous Welding of AISI 316L Stainless Steel and Steel Using Pulsed Nd: YAG Laser

An attempt made to optimize the operating parameters involved in an autogenous pulsed Nd: YAG laser welding process of similar and dissimilar combinations of butt joint of 2 mm thick 316 L stainless steel and mild steel. Influence of prominent laser welding parameters such as average peak power, defocus position, spot position, and shielding gas were investigated for welded joints considered. T...

Effect of Crystallographic Orientation on the Pitting Corrosion Resistance of Laser Surface Melted AISI 304L Austenitic Stainless Steel

The localized corrosion behavior of laser surface melted 304L austenitic stainless steel was studied by potentiodynamic polarization test. The extent of improvement in corrosion resistance was governed by the preferred orientation and the percentage of delta ferrite present on the surface of the laser melted sample. It was established by orientation imaging microscopy that the highest pitting p...