Comparison of strain measurement in the mouse forearm using subject-specific finite element models, strain gaging, and digital image correlation
نویسندگان
چکیده
منابع مشابه
Use of Digital Image Correlation for Validation of Surface Strain in Specimen-specific Vertebral Finite Element Models
Finite element (FE) models of the spine are typically validated to be similar to the average experimental response of specimens with anatomical variation, such as varying sizes and degrees of degeneration. To account for this variation in a manner that allows validation against a specific vertebral response instead of an average range, specimen-specific models can be developed. The purpose of t...
متن کاملInvestigation of Strain Measurements using Digital Image Correlation with a Finite Element Method
This article proposes a digital image correlation (DIC) strain measurement method based on a finite element (FE) algorithm. A two-step digital image correlation is presented. In the first step, the gradientbased subpixels technique is used to search the displacements of a region of interest of the specimen, and then the strain fields are obtained by utilizing the finite element method in the se...
متن کاملSubject-specific Finite Element Models Can Predict Strain in the Human Medialcollateral Ligament under Valgus Loading
INTRODUCTION: Despite the many investigations of ligament function, the exact role of specific ligaments in maintaining joint stability, the cause and effect of injuries, and the efficacy of various reconstructive procedures remain unclear or unknown. This is partially due to inherent measurement limitations of experimental studies. The finite element (FE) method can predict spatial and tempora...
متن کاملCorrecting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Biomechanics and Modeling in Mechanobiology
سال: 2017
ISSN: 1617-7959,1617-7940
DOI: 10.1007/s10237-017-0885-7