Comparison of open circuit voltage generated by tracking solar panel and static solar panel using arduino board
نویسندگان
چکیده
منابع مشابه
Real Time Data Acquisation of Solar Panel Using Arduino and Further Recording Voltage of the Solar Panel
This paper presents the simulation of real time data acquisition of a solar panelin LabVIEW. A prototype model has been made where two Arduino were used. One is used for interfacing the solar panel with the PC for acquisition of data and the other one isused with the servomotor. The servomotor is linked with the solar panel with the help of a shaft and is rotated according to the LDR output. Tw...
متن کاملComparison between four dissimilar solar panel configurations
Several studies on photovoltaic systems focused on how it operates and energy required in operating it. Little attention is paid on its configurations, modeling of mean time to system failure, availability, cost benefit and comparisons of parallel and series–parallel designs. In this research work, four system configurations were studied. Configuration I consists of two sub-components arranged ...
متن کاملIntegrated solar panel antennas
Introduction: Autonomous communications systems often involve the use of separate solar cells and antennas, which necessitate a compromise in the utilisation of the limited surface area available. These separate items may be combined thus saving valuable ‘real estate’, provided that the antennas and solar cells are compatible [1]. One method for achieving this is to integrate the two kinds of d...
متن کاملScattering of Solar Flux by Panel Grooves
The amount of scattering of solar radiation by grooves machined into the surfaces of the MMA antenna panels is estimated. Circular cross-section grooves are found to be much more effective than triangular grooves since they scatter over a wider range of angles. The groove pitch should be comparable to or smaller than the wavelength at the highest operating frequency, or about 100300 μm, and ha...
متن کاملImproving Solar Panel Efficiency Using Reinforcement Learning
Solar panels sustainably harvest energy from the sun. To improve performance, panels are often equipped with a tracking mechanism that computes the sun’s position in the sky throughout the day. Based on the tracker’s estimate of the sun’s location, a controller orients the panel to minimize the angle of incidence between solar radiant energy and the photovoltaic cells on the surface of the pane...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering, Science and Technology
سال: 2020
ISSN: 2141-2839,2141-2820
DOI: 10.4314/ijest.v12i2.9