Comparison of Drawability between Warm Forming and Cold Forming of Aluminum 6xxx Alloys
نویسندگان
چکیده
منابع مشابه
Investigating the Effects of Cold Bulge Forming Speed on Thickness Variation and Mechanical Properties of Aluminum Alloys: Experimental and Numerical
In this work, cold bulge forming of an Aluminium-Magnesium (Al-Mg) sheet with a solid bulging medium is performed experimentally and numerically. Mechanical properties and thickness variations of Al-Mg sheet are evaluated before and after the forming process. The results indicated that the Al-Mg sheet has taken the desired shape without necking using the cold bulge forming process. Also, the...
متن کاملExperimental Study on Warm Incremental Tube Forming of AA6063 Aluminum Tubes
Effect of temperature on formability of AA6063 aluminum tubes in incremental forming process was investigated. Experiments are performed on AA6063 aluminum tubes. A spirally moving tool incrementally expands the tube wall. The tube is clamped from both ends while the deformation zone is not in contact with the die. A circumferential heating system is used to heat the tube due to the low formabi...
متن کاملDuctility of 6XXX aluminum alloys at high temperature
3914)"Graduate Student, Department of Materials Science & Engineering, Faculty of Engineering, Shibaura Institute of Technology (3914 Shibaura, Minato-ku, Tokyo 1088548). 芝浦工業大学大学院生(東京都)〔現在財日本品質保証機構(東京都)〕"Graduate Student, Shibaura Institute of Technology (Minatoku, Tokyo).〔Present: Japan Quality Assurance Organization (Setagaya-ku, Tokyo)〕. 芝浦工業大学工学部(東京都)"Faculty of Engineering, Sh...
متن کاملThe Effects of Forming Parameters on the Single Point Incremental Forming of 1050 Aluminum Alloy Sheet
The single point incremental forming (SPIF) is one of the dieless forming processes which is widely used in the sheet metal forming. The correct selection of the SPIF parameters influences the formability and quality of the product. In the present study, the Gurson-Tvergaard Needleman (GTN) damage model was used for the fracture prediction in the numerical simulation of the SPIF process of alum...
متن کاملStress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2018
ISSN: 1757-899X
DOI: 10.1088/1757-899x/418/1/012029