Comparison among Mechanical Properties of Investment-Cast c.p. Ti, Ti-6Al-7Nb and Ti-15Mo-1Bi Alloys
نویسندگان
چکیده
منابع مشابه
Comparison among Mechanical Properties of Investment-Cast c.p. Ti, Ti-6Al-7Nb and Ti-15Mo-1Bi Alloys
The present study compares castability and mechanical performance among alloys of c.p. Ti, Ti-6Al-7Nb and a newly-developed Ti-15Mo-1Bi in regard to their as-cast state. Experimental results indicate that average cast length of Ti-6Al-7Nb appears a little lower than c.p. Ti and Ti-15Mo-1Bi, although the differences are not significant. C.p. Ti has an hcp phase of lath-type morphology with serra...
متن کاملMechanical properties and grindability of dental cast Ti-Nb alloys.
Aiming at developing a dental titanium alloy with better mechanical properties and machinability than unalloyed titanium, a series of Ti-Nb alloys with Nb concentrations up to 30% was made. They were cast into magnesia-based molds using a dental casting machine and the mechanical properties and grindability of the castings were examined. The hardness of the alloys with Nb concentrations of 5% a...
متن کاملMechanical properties and microstructures of dental cast Ti-Ag and Ti-Cu alloys.
In this study, experimental Ti-Ag alloys (5, 10, and 20 mass% Ag) and Ti-Cu alloys (2, 5, and 10 mass% Cu) were made in an argon-arc melting furnace. The alloys were cast into magnesia molds using an argon gas-pressure dental casting machine, and the mechanical properties and microstructures of the castings were investigated. As the concentration of silver or copper in the alloys increased, the...
متن کاملMechanical properties and microstructural evolution of vacuum hot-pressed titanium and Ti-6Al-7Nb alloy.
Hot-pressing is a powder metallurgy process where loose powder is loaded into a mould, usually of graphite, and sintered by the simultaneous application of high temperature and pressure. In this study elemental titanium and Ti-6Al-7Nb alloy powders are hot-pressed under different conditions in order to study the influence of the processing parameters on the microstructure and mechanical propert...
متن کاملMicrostructure and mechanical behaviour of the isothermally forged Ti-6Al-7Nb alloy
The mechanical properties of the Ti-6Al-7Nb alloy, used to manufacture high-strength prostheses, are highly dependent on its microstructure. This work presents the microstructural changes of this alloy under isothermal hot working. It is shown that microstructure is strongly affected by strain rate, temperature and strain. The possible precipitation of intermetallic phases is also evaluated. To...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2004
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.45.3028