Comparative Study of Power Factor Correction and THD Minimization Using Boost Converter and Interleaved Boost Converter Using Pi Controller
نویسندگان
چکیده
منابع مشابه
Simulation of Active Power Factor Correction Using Boost Type Converter
With the vast development in the usage of Power electronic devices like Rectifiers (nonlinear loads) the current drawn from the line is distorted resulting in a High Total Harmonic Distortion (THD) and Low Power Factor (PF). Hence there is a continuous need for Power factor improvement and reduction of line current harmonics. The most popular topology for Active PFC is a boost converter as it d...
متن کاملLM5032 Interleaved Boost Converter
The LM5032 dual current mode PWM controller contains all the features needed to control an interleaved boost converter. The two outputs operate 180 degrees out of phase and have separate current limit inputs for each channel. In addition to a high input voltage range, the controller contains all the auxiliary features needed to control a complete converter. Introduction A basic boost converter ...
متن کاملDesign and Simulation of Boost Converter for Power Factor Correction and THD Reduction
In an electrical Power systems, a load with a low power factor draws more current than a load with a high power factor for the same amount of useful power transferred. Linear loads with low power factor (induction motor) can be corrected with a passive network of capacitors or inductors. The hysteresis current controller is used to track the line current command. Non-linear loads (rectifier) di...
متن کاملDesign and Analysis of Predictive control using PI controller for Boost Converter with Active Power Factor Correction
Power factor correction of boost converter is done by using predictive control strategy. In this paper predictive control algorithm is presented based on this algorithm all of the duty cycles required to achieve unity power factor in one half line period are calculated in advance by proportional Integral (PI) controller, the simulation results show that the proposed predictive strategy for PFC ...
متن کاملImproved Parallel Boost Power Converter for Power Factor Correction
The main objective of the study is to analysis and design parallel boost power converter for power factor correction using an active filtering approach by implementing single-phase soft-switching technique with an active snubber circuit. Zero voltage transition to turn ON and zero current transition to turn OFF is implemented by the active snubber circuit for the main switches with no any furth...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering
سال: 2015
ISSN: 2320-3765,2278-8875
DOI: 10.15662/ijareeie.2015.0401016