Comparative Study of Forward and Backward Flow Forming Process using Finite Element Analysis
نویسندگان
چکیده
منابع مشابه
Optimization of the strain distribution in the roll forming process using the desirability function and finite element methods
Defects of the roll forming process are affected by amount and situation of the strains distribution. The effect of the process parameters on the strain distribution in the round cross section roll forming process has been studied. Finite element and response surface method have been used for process modelling. Then desirability functions approach and overlaid counter plots have been employed f...
متن کاملanalysis of three dimensional of forward extrusion using slab method and finite element
slab method of analysis has been used for solving metal forming problems for a long time. however it has been restricted to plane strain and axisymmetric problems due to limitations in its formulations. in this paper a new formulation has been proposed so that it could be applied to three dimensional problems in metal forming. a parametric slab has been considered in this analysis and the force...
متن کاملFE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملAnalysis of deep drawing process to predict the forming severity considering inverse finite element and extended strain-based forming limit diagram
An enhanced unfolding Inverse Finite Element Method (IFEM) has been used together with an extended strain-based forming limit diagram (EFLD) to develop a fast and reliable approach to predict the feasibility of the deep drawing process of a part and determining where the failure or defects can occur. In the developed unfolding IFEM, the meshed part is properly fold out on the flat sheet and tre...
متن کاملThe Relationship between Constant Friction Factor and Coefficient of Friction in Metal Forming using Finite Element Analysis
Frictional shear stress is usually determined by utilizing the coefficient of friction or the constant friction factor models. The present study deals with finite element analysis of double cup extrusion process to determine the relationship between constant friction factor (m) and coefficient of friction (µ), since the metal flow in this process is very sensitive to frictional conditions. Ther...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bonfring International Journal of Industrial Engineering and Management Science
سال: 2015
ISSN: 2250-1096,2277-5056
DOI: 10.9756/bijiems.8053