Comparative modeling results for ridge waveguide MQW and hybrid Si/III-V lasers
نویسندگان
چکیده
منابع مشابه
High Power 1300 nm Fabry-Perot and DFB Ridge Waveguide Lasers
In this paper we summarize the results [1] on the development of high power 1300 nm ridge waveguide Fabry-Perot and distributed-feedback (DFB) lasers. Improved performance of MOCVD grown InGaAsP/InP laser structures and optimization of the ridge waveguide design allowed us to achieve more than 800 mW output power from 1300 nm single mode Fabry-Perot lasers. Despite the fact that the beam aspect...
متن کاملA Ridge Waveguide for Thermo-optic Application
A thermal analysis and structure of a ridge single mode waveguide with a metal heater are presented. The steady-state temperature increases linearly and the thermal response becomes slower at the same power consumption, when the under-etched depth in the lower cladding increases. When the upper cladding thickness decreases, the thermal response becomes faster. This shows that a thinner upper cl...
متن کاملHigh-efficiency native-oxide-passivated high-index-contrast ridge waveguide lasers
A GaAs-based high-index-contrast ridge waveguide laser is fabricated using a self-aligned process of deep dry etching plus oxygen-enhanced wet thermal oxidation of low Al-content AlGaAs. Lasers operating at l1⁄4 813 nm (CW, 300 K) with external differential quantum efficiencies as high as 78% are demonstrated, indicating effective passivation of the directly-oxidised etched active region sidewa...
متن کاملNarrow ridge waveguide high power single mode 1.3-μm InAs/InGaAs ten-layer quantum dot lasers
Ten-layer InAs/In0.15Ga0.85As quantum dot (QD) laser structures have been grown using molecular beam epitaxy (MBE) on GaAs (001) substrate. Using the pulsed anodic oxidation technique, narrow (2 lm) ridge waveguide (RWG) InAs QD lasers have been fabricated. Under continuous wave operation, the InAs QD laser (2 · 2,000 lm) delivered total output power of up to 272.6 mW at 10 C at 1.3 lm. Under p...
متن کاملImproved Temperature Performance of 1.31- m Quantum Dot Lasers by Optimized Ridge Waveguide Design
In this letter, we demonstrate the importance of the fabricated device structure for the external differential efficiency, threshold current density, and maximum operating temperature for ground state operation of a 1.31m quantum dot laser. The introduction of a shallow ridge etch design and selective electroplating of the gold bondpads is demonstrated to offer improved performance in compariso...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Radiation Research and Applied Sciences
سال: 2018
ISSN: 1687-8507
DOI: 10.1016/j.jrras.2017.11.004