Comparative Investigations on Microstructure and Slurry Abrasive Wear Resistance of NiCrBSi and NiCrBSi-WC Composite Hardfacings Deposited on 304 Stainless Steel
نویسندگان
چکیده
منابع مشابه
Investigation of Hardness, Morphology and Structural Analysis of NiCrBSi Composite Coating on Plain Carbon Steel
High velocity oxy-fuel (HVOF) is one of the emerging technologies among the thermal spraying techniques, for producing uniform and dense coatings, having high hardness and very low porosity. A NiCrBSi alloy coating was prepared with approximately 400µm thick, on the A516 steel by means of HVOF and was analyzed with regard to its detailed microstructures, phase formation, thickness, roughness an...
متن کاملThe Effect of Low Dose-Rate Irradiation on the Microstructure of 304 Stainless Steel*
Changes in mechanical and corrosion properties caused by the development of radiationinduced microstructure have relevance to the aging and lifetime extension of light water reactors (LWR’S). However, much of the current data related to microstructural development in irradiated metals are generated from studies carried out at much higher dose-rates than encountered in LWR’S. An opportunity exis...
متن کاملComparative study on corrosion resistance and in vitro biocompatibility of bulk nanocrystalline and microcrystalline biomedical 304 stainless steel.
OBJECTIVES SUS 304 stainless steels have been widely used in orthodontics and implants such as archwires, brackets, and screws. The purpose of present study was to investigate the biocompatibility of both the commercial microcrystalline biomedical 304 stainless steel (microcrystalline 304ss) and novel-fabricated nanocrystalline 304 stainless steel (nanocrystalline 304ss). METHODS Bulk nanocry...
متن کاملCompressibility of 304 Stainless Steel Powder Metallurgy Materials Reinforced with 304 Short Stainless Steel Fibers
Powder metallurgy (P/M) technique is usually used for manufacturing porous metal materials. However, some P/M materials are limitedly used in engineering for their performance deficiency. A novel 304 stainless steel P/M material was produced by a solid-state sintering of 304 stainless steel powders and 304 short stainless steel fibers, which were alternately laid in layers according to mass rat...
متن کاملExperimental investigations from conventional to high speed milling on a 304-L stainless steel
Last years analytical or finite element models of milling become more efficient and focus on more physical aspects, nevertheless the milling process is still experimentally unknown on a wide range of use. This paper propose to analyse with accuracy milling operations by investigating the cutting forces values, shape of cutting forces curves obtained for different cutting speeds, and related phe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tribology in industry
سال: 2022
ISSN: ['2217-7965', '0354-8996']
DOI: https://doi.org/10.24874/ti.1075.03.21.05