Comparative Efficiencies for Phenol Degradation on Solar Heterogeneous Photocatalytic Reactors: Flat Plate and Compound Parabolic Collector

نویسندگان

چکیده

Phenol is a recalcitrant anthropogenic compound whose presence has been reported in both wastewater and drinking water; human exposure to phenolic substances can lead health problems. The degradation of phenol (measured as COD decrease) through solar heterogeneous photocatalysis with immobilized TiO2 was performed two different reactors: flat-plate reactor (FPR) parabolic collector (CPC). A 23 full factorial experimental design followed. variables were the TiO2, H2O2 addition, type reactor. Data fitted pseudo-first-order reaction-rate-kinetics model. rate constant for photocatalytic 1 mM 6.6 × 10?3 min?1 FPR 5.9 CPC. calculated figures merit analyzed MANCOVA, UV fluence covariate. An ANCOVA showed that reactor, or had no statistically significant effect on results, but there TiO2. According (p < 0.05). CPC average 17.4% more efficient than when it came area per order (ACO) by addition.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design and Development of Compound Parabolic Concentrating Solar Collector with Flat Plate Absorber

In this research work 2-D CPC (Compound Parabolic Concentrator) with flat plate absorber and two parabolic reflectors is first designed and then fabricated for thermal performance analysis. Here the incident rays, after reflection from the reflector, are not focused at a point but are simply collected on a line of absorber surface. Acrylic sheets are provided to reduce the heat loss. Flat plate...

متن کامل

Modeling of Flat-Plate Solar Collector Operation in Transient States

Saleh, Ahmad M. M.S.E., Purdue University, May 2012. Modeling Of Flat-Plate Solar Collector Operation in Transient States. Major Professor: Hosni Abu-Mulaweh. Solar energy is becoming an alternative for the limited fossil fuel resources. One of the simplest and most direct applications of this energy is the conversion of solar radiation into heat, which can be used in water heating systems. A c...

متن کامل

design, construction and evaluation of solar flat-plate collector simulator based on the thermohydraulic coefficient

introduction increasing the area of absorber plate between the flowed air through the duct can be accomplished by corrugating the absorber plate or by using the artificial roughness underside of the absorber plate as the commercial methods for enhancing the thermohydraulic performance of the flat plate solar air heaters. evaluation of this requires the construction of separated solar air heater...

متن کامل

Energy, economic and environmental analysis of metal oxides nanofluid for flat-plate solar collector

For a solar thermal system, increasing the heat transfer area can increase the output temperature of the system. However, this approach leads to a bigger and bulkier collector. It will then increase the cost and energy needed to manufacture the solar collector. This study is carried out to estimate the potential to design a smaller solar collector that can produce the same desired output temper...

متن کامل

Sensitivity Analysis of the Test Parameters of a Solar Flat Plate Collector for Performance Studies

The BIS test procedure for performance of solar flat plate collectors allows a certain limit of deviation for the control parameters to define the steady state condition. During actual performance studies, sometimes these limits are exceeded. In this paper an attempt has been made to find out the effect on the performance curve of the collector as a result of exceeding this prescribed limit by ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Catalysts

سال: 2022

ISSN: ['2073-4344']

DOI: https://doi.org/10.3390/catal12060575