منابع مشابه
Nonstationary Velocity Profiles for Emergency Vehicles on Automated Highways
This paper explores the notion and usefulness of nonstationary velocity profiles for high priority emergency vehicle transit on automated highways. These profiles are intended for use in the link layer of the hierarchical control architecture defined by the California Partners for Automated Transit and Highways (PATH) program. A non-stationary velocity profile which can be used to circulate tra...
متن کاملSystem Standards for Drivers, Vehicles and Highways
N A T IO N A L T R A N S P O R T A T IO N SAFETY BO ARD The National Transportation Safety Board was established by Congress in the Department of Transportation Act of 1966. The safety board’s basic functions include the investigation of major trans portation accidents in all modes of transportation and the execution of special studies of safety problems which influence casualties in trans po...
متن کاملAutomated Highways And The Free Agent Demonstration
In August of 1997, The US National Automated Highway System Consortium (NAHSC) presented a proof of technical feasibility demonstration of automated driving. The 97 Demo took place on car-pool lanes on I15 in San Diego, California. Members of the Consortium demonstrated many different functions, including: Vision-based road following Lane departure warning Magnetic nail following Radar reflecti...
متن کاملThe Impact of Heavy Vehicles on Residents on Arterial Roads and State Highways
This paper describes investigations that have been undertaken on the effect of heavy vehicle traffic on residents. The study focused on sixteen roads in four North Island communities. The roads selected were predominantly regional arterial roads and had heavy vehicle volumes ranging from 2.1% to 32% of total traffic volume. The study had two main components, a residents' survey and an environme...
متن کاملA Special Fiber Optic Sensor for Measuring Wheel Loads of Vehicles on Highways
This paper presents results from an investigation on a special optical fiber as a load sensor for application in Weigh-in-Motion (WIM) systems to measure wheel loads of vehicles traveling at normal speed on highways. The fiber used has a unique design with two concentric light guiding regions of different effective optical path lengths, which has the potential to enable direct measurement of ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of Land & Public Utility Economics
سال: 1925
ISSN: 1548-9000
DOI: 10.2307/3138646