Combustion Products of Poly (vinyl chloride).
نویسندگان
چکیده
منابع مشابه
Poly(vinyl chloride) processes and products.
Poly(vinyl chloride) resins are produced by four basic processes: suspension, emulsion, bulk and solution polymerization. PVC suspensions resins are usually relatively dust-free and granular with varying degrees of particle porosity. PVC emulsion resins are small particle powders containing very little free monomer. Bulk PVC resins are similar to suspension PVC resins, though the particles tend...
متن کاملWorker exposure to vinyl chloride and poly(vinyl chloride).
The National Institute for Occupational Safety and Health (NIOSH) in early 1974 began industrial hygiene studies of vinyl chloride exposed workers. Three VC monomer plants, three VC polymerization plants, and seven PVC fabrication plants were surveyed. V polymerization plant workers and workers in one job category in VC monomer plants were exposed to average levels above 1 ppm. The highest aver...
متن کاملIndustrial preparation of poly(vinyl chloride).
Vinyl chloride (VCM) is unloaded from railroad tank cars or tank trucks into pressurized storage spheres. VCM, emulsifiers, and catalysts are metered into polymerization vessels wherein PVC is produced through a chemical reaction in an aqueous medium under controlled conditions of temperature and pressure. After the reaction reaches a predetermined completion, the contents are transferred to a ...
متن کاملEffect of some additives on degradation of poly (vinyl chloride- co- vinyl
The thermal decomposition of 86 % vinyl chloride 14 % vinyl acetate copolymer wasstudied by the conductometry technique in the presence of nitrogen. The kinetics of stability andthermal degradation of vinyl chloride- co- vinyl acetate (PVC- co- PVAc) copolymer withcopper, copper oxide and tricalcium dicitrate (st) were investigated at various temperatures (150-180 oC ) in solution. The rate coe...
متن کاملPhotodegradation of Poly ( caprolactone ) / Poly ( vinyl chloride ) Blend
The photodegradation of a 1:1 blend of poly (caprolactone) and poly(vinyl chloride) has been studied by following carbon dioxide emission during UV exposure. Similar measurements were made on poly(caprolactone) and poly(vinyl chloride) homopolymers prepared and irradiated in the same way. It was found that the blend gave lower CO2 emission than either of the two homopolymers, indicating that th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Environmental Chemistry
سال: 1991
ISSN: 1882-5818,0917-2408
DOI: 10.5985/jec.1.525