Combining XRD with Hole-Drilling Method in Residual Stress Gradient Analysis of Laser Hardened C45 Steel
نویسندگان
چکیده
منابع مشابه
Residual Stress Characterization in Orthotropic Plate by Combining Hole-drilling Method and Speckle Interferometry
Novel method for a determination of residual stresses in orthotropic composite plates based on local displacement measurements by electronic speckle-pattern interferometry is developed and verified. The values of hole diameter increments in principal residual stress directions serves as initial experimental deformation. The technique is based on analytical solution of S.G. Lekhnitsky, which des...
متن کاملEffect of the Hole-bottom Fillet Radius on the Residual Stress Analysis by the Hole Drilling Method
The hole drilling method is based on the measuring of the surface relaxed strains when a small hole is drilled on the examined component. From the relaxed strains, measured generally by using special strain gage rosette, the residual stresses is computed by using proper influence coefficients, provided also by the ASTM E837-08 standard. Such influence coefficients are obtained by numerical simu...
متن کاملDual-axis Hole-drilling Espi Residual Stress Measurements
A dual-axis ESPI hole-drilling residual stress measurement method is described. It has the advantage of evaluating all the in-plane normal stress components with similar response to measurement errors, significantly lower than with single-axis measurements. Experimental tests were done on a stressed specimen, and the results supported theoretical expectations.
متن کاملResidual Stress Measurement of 7050 Aluminum Alloy Open Die Forgings Using the Hole-Drilling Method
Since this project is a result of a class assignment, it has been graded and accepted as fulfillment of the course requirements. Acceptance does not imply technical accuracy or reliability. Any use of the information in this report, including numerical data, is done at the risk of the user. These risks may include catastrophic failure of the device or infringement of patent or copyright laws. T...
متن کاملMicro-hole drilling with femtosecond fiber laser
In this paper, micro-hole drilling in ambient air is presented using fs fiber laser (750 fs & 1030 nm). Micro holes were fabricated in both transparent (glasses) and non-transparent materials (metals and tissues). Hole shape and morphology was characterized and evaluated with optical microscope and scanning electron microscopy (SEM). Debris-free micro holes with good roundness and no thermal da...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Materials Research
سال: 2014
ISSN: 1662-8985
DOI: 10.4028/www.scientific.net/amr.996.277