COLOR MEASUREMENTS OF ELECTROPLATED GOLD FILM ON HULL CELL PANELS
نویسندگان
چکیده
منابع مشابه
Electromigration of Electroplated Gold Interconnects
Electromigration tests were performed on passivated electroplated Au four terminal Kelvin line structures using the conventional in situ resistance monitoring technique. The stress conditions were a current density of 2.0 MA/cm with ambient temperatures ranging from 325°C to 375°C. The temperature coefficients of resistance (TCR) values were measured prior to current stressing to calculate the ...
متن کاملMechanism for Cu void defect on various electroplated film conditions
This study observes that copper (Cu) films deposited by high current densities or in an aged electrolyte easily generate void defects after chemical mechanical polishing (CMP). The (111)/(200) ratio and the impurity amount of an electroplated Cu film are found to have strong correlation with the formation of void defects. Furthermore, pulse-reverse waveform plating following direct current plat...
متن کاملYoung’s modulus of electroplated Ni thin film for MEMS applications
The Young’s modulus of an electroplated nickel (Ni) thin film suitable for microelectromechanical applications has been investigated as a function of process variables: the plating temperature and current density. It was found that the Young’s modulus is approximately 205 GPa at plating temperatures less than 60 jC, close to that of bulk Ni, but drastically drops to approximately 100 GPa at 80 ...
متن کاملStress in electroplated gold on silicon substrates and its dependence on cathode agitation
The influence of cathode agitation on the residual stress of electroplated gold has been investigated. Using a custom-built plating cell, a periodic, reciprocating motion was applied to silicon substrates that were electroplated with soft gold. A commercially available gold sulfite solution was used to deposit the 0.6 lm thick gold films using a current density of 3.0 mA/cm and a bath temperatu...
متن کاملResidual Stress and Microstructure of Electroplated Cu Film on Different Barrier Layers
Copper films of different thicknesses between 0.2 and 2 microns were electroplated on adhesion-promoting TiW and Ta barrier layers on <100> single crystal 6-inch silicon wafers. The residual stress was measured after each processing step using a wafer curvature technique employing Stoney’s equation. Large gradients in the stress distributions were found across each wafer. Controlled Cu grain gr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2013
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2013.0207002