Collapse of Thin Walled Rectangular-Section Beam under Three-Point Bending.
نویسندگان
چکیده
منابع مشابه
Experimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads
In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...
متن کاملExperimental Investigations into the Collapse of Simple and Reinforced Thin-Walled Channel Beams under Bending Loads
In this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. Many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. Since the available theories in this area are complicated and little attention has been paid to...
متن کاملexperimental investigations into the collapse of simple and reinforced thin-walled channel beams under bending loads
in this paper, collapse behavior of simple and reinforced thin-walled channel- section beams, subjected to three- point bending, is investigated. many simple channel- section beams of different geometry and some reinforced ones were tested, and their strengths after collapse were obtained thoroughly. since the available theories in this area are complicated and little attention has been paid to...
متن کاملThin-walled beams: the case of the rectangular cross-section
In this paper we present an asymptotic analysis of the three-dimensional problem for a thin linearly elastic cantilever Ωε = ωε × (0, l) with rectangular cross-section ωε of sides ε and ε 2, as ε goes to zero. Under suitable assumptions on the given loads, we show that the threedimensional problem converges in a variational sense to the classical one-dimensional model for extension, flexure and...
متن کاملAnalysis of the Rotary-draw Bending Process for Thin-walled Rectangular Aluminum Tube
The Rotary-Draw Bending (RDB) process is a distinguished process employed for the precision cold bending of a hollow tube with small radius bends using Numerical Control (NC) machines. This research presents an analytical model based on the power law hardening model for the RDB processing of rectangular thin tubes. Based on the constraints of the tube in the dies and its thinness, the plane str...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1993
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.59.2920