Cold-Sprayed Cu-MoS2 and Its Fretting Wear Behavior
نویسندگان
چکیده
منابع مشابه
Numerical Modeling of Fretting Wear
In this paper, a review of some techniques proposed in the literature for modelling fretting wear is presented. Fretting wear occurs when surfaces are degraded and materials are removed due to a small relative oscillatory motion between two contact surfaces. Due to the continuous change in the shape of a structure during its lifetime, the design of engineering components subjected to fretting w...
متن کاملEffects of Plasma ZrN Metallurgy and Shot Peening Duplex Treatment on Fretting Wear and Fretting Fatigue Behavior of Ti6Al4V Alloy
A metallurgical zirconium nitride (ZrN) layer was fabricated using glow metallurgy using nitriding with zirconiuming prior treatment of the Ti6Al4V alloy. The microstructure, composition and microhardness of the corresponding layer were studied. The influence of this treatment on fretting wear (FW) and fretting fatigue (FF) behavior of the Ti6Al4V alloy was studied. The composite layer consiste...
متن کاملStudy of Wear Behaviour of Hvof and Cold Sprayed Coatings on Boiler Steels
In this study two commonly used steels in boiler plants, i.e. (SAE-213) T-22 and SA516 (Grade-70) were coated with different thermal spray processes namely HVOF and cold spray. The coating powder used was made up of NiCrTiCRe powder. The performance of the coated as well as uncoated material was investigated using a pin-on-disc machine [Model: Wear and Friction Monitor Tester TR-20], supplied b...
متن کاملStudy of tribological behavior of Cu–MoS2 and Ag–MoS2 nanocomposite lubricants
Tribological behavior of Cu-MoS2 and Ag-MoS2 nanocomposite lubricant was studied. Cu nanoparticles produced by electrical explosion of copper wires and Ag nanoparticles prepared by electrospark erosion were employed as metal cladding modifiers of MoS2 nanolamellar particles. The tribological tests showed Cu-MoS2 and Ag-MoS2 nanocomposite lubricants changed the friction coefficient of the initia...
متن کاملInterference Assembly and Fretting Wear Analysis of Hollow Shaft
Fretting damage phenomenon often appears in the interference fit assembly. The finite element model of hollow shaft and shaft sleeve was established, and the equivalent stress and contact stress were computed after interference assembly. The assembly body of hollow shaft and shaft sleeve was in whirling bending load, and the contact status (sticking, sliding, and opening) and the distribution o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Thermal Spray Technology
سال: 2015
ISSN: 1059-9630,1544-1016
DOI: 10.1007/s11666-015-0372-6