Cold 2-Stages Stamping of Magnesium Alloy CupsHaving Small Corner Radius

Effect of Die Corner Radius and Punch Corner Radius on Wrinkling and Fracture Limits in Deep Drawing of Cylindrical Cup

Wrinkling and fracture are the important defects in deep drawing operation, which can be prevented using blank holding force (BHF) which has to be optimized as lower BHF promotes wrinkles formation and higher BHF promotes fracturing. Hence the limits of wrinkling and fracture have to be established. These limits depend on various tooling and process parameters. In this work the effect of toolin...

Statistical analysis on static recrystallization texture evolution in cold-rolled AZ31 magnesium alloy sheet.

Cast AZ31B-H24 magnesium alloy, comprising Mg with 3.27 wt% Al and 0.96 wt% Zn, was cold rolled and subsequently annealed. Global texture evolutions in the specimens were observed by X-ray diffractometry after the thermomechanical processing. Image-based microstructure and texture for the deformed, recrystallized, and grown grains were observed by electron backscattered diffractometry. Recrysta...

Microstructure-sensitive investigation of magnesium alloy fatigue

Kinetics of SIMA AZ80 Magnesium Alloy

Semi-solid feedstock of AZ80 magnesium alloy modified by [trace] rare-earth Y element 10 (0, 0.2, 0.4, 0.8 wt.%) were fabricated by [strain-induced melting activation] (SIMA) in the form of 11 extrusion and partial remelting. The effect of Y addition on the microstructure evolution of [the] 12 extruded and [isothermally heat] treated alloy was observed by [using an] optical microscope (OM), 13 ...

Influence of Outer Corner Radius in Equal Channel Angular Pressing

Equal Channel Angular Pressing (ECAP) is currently being widely investigated because of its potential to produce ultrafine grained microstructures in metals and alloys. A sound knowledge of the plastic deformation and strain distribution is necessary for understanding the relationships between strain inhomogeneity and die geometry. Considerable research has been reported on finite element analy...