Coating of urea granules by in situ polymerization in fluidized bed reactors

Experimental Study of Coating in a Bottom Sprayed Fluidized Bed

Several investigations have been devoted towards understanding the coating process in fluidized beds. Most of these studies focused on spraying liquid droplets over the bed. However, due to the complexity of these systems, more investigations are still required to quantify the effect of operating conditions on the coating criteria. The present work aims at fundamentally understanding and pr...

24 Fixed Film Stationary Bed and Fluidized Bed Reactors

GASIFICATION vs COMBUSTION OF WASTE/BIOMASS IN FLUIDIZED BED REACTORS

This paper presents a comparison of commercial fluidized bed gasifiers and combustors used to recover energy from municipal solid wastes and biomass. The work reported here is excerpted from four case studies prepared for the International Energy Agency’s Bioenergy Agreement, under Task 23 (Energy from Thermal Conversion of MSW and RDF, 1998-2000) and Task 36 (Energy from Integrated Solid Waste...

Modeling of Non-isothermal Reacting Flow in Fluidized Bed Reactors

Abstract: We investigate a prototype concept of a back-up electricity device where we use liquid formic acid (FA) to produce a mixture of carbon dioxide (CO2) and hydrogen (H2) which is used in a PEM fuel cell, Fig. 1. In the fluidized bed reactor the liquid FA is decomposed to a gaseous mixture of CO2 and H2 in the presence of microscopic floating solid catalytic particles. We describe the sys...

Early Detection of Agglomeration in Fluidized Bed Polymerisation Reactors

Polyethylene (PE) and polypropylene (PP) make up for a large part of the total worldwide polymer production. Originally, both polymers were often produced in solution processes. However, fluidized bed reactors for polyethylene and polypropylene production gain increasing industrial interest because of the relatively low production costs, the ability to produce a wide range of polymer grades, an...