CO2 Laser Welding Characteristics of 800 MPa Class TRIP Steel

Simulation Study on Thermo-Mechanical Controlled Process of 800 MPa-Grade Steel for Hydropower Penstocks

The thermo-mechanical controlled process (TMCP) of 800-MPa-grade non-quenched tempered steel used for penstocks was simulated on a Gleeble-3500 thermo-mechanical simulator. The effect of the finish cooling temperature (FCT) which ranged from 350–550 ◦C on the microstructure and mechanical properties was studied. The microstructure of TMCP specimens is primarily composed of lath bainite (LB) and...

Blue-light hazard from CO2 arc welding of mild steel.

OBJECTIVES The objective was to quantify the blue-light hazard from CO(2) arc welding of mild steel. METHODS The spectral radiance of arcs in CO(2) arc welding of mild steel was measured for solid and flux-cored wires at welding currents of 120-480 A. Effective blue-light radiance and the maximum acceptable exposure duration were calculated from the spectral radiance using their definitions i...

TRIP steel

A combination of neural networks and genetic algorithms has been used to design a TRIP assisted steel in which the silicon concentration is kept low. In this context, the steel has a novel microstructure consisting of d ferrite dendrites and a residual phase which at high temperatures is austenite. This austenite can, with appropriate heat treatment, evolve into a mixture of bainitic ferrite an...

Characteristics of Monitor for Laser Welding

Effect of Laser Welding on Formability of DP980 steel

Limiting dome height (LDH) tests were used to evaluate the formability of laser butt welded blanks of the dual phase 980 steel in comparison with the base metal. Two different lasers were used: diode and Nd:YAG, giving a wide range of welding thermal cycles. A sharp decrease in LDH was observed in the welded specimens due to the formation of a softened zone in the outer heat affected zone. Soft...