CMOS Cascode Low Noise Amplifier (CCLNA) Design for Nanosensor Applications
نویسندگان
چکیده
منابع مشابه
A 2.4GHz Cascode CMOS Low Noise Amplifier
A cascode CMOS low noise amplifier (LNA) is presented along with the used design methodology and measurement results. The LNA works at 2.4 GHz with 14.5 dB voltage gain and 2.8 dB simulated noise figure (NF). Powered from a 1.8 V supply, the core measured current consumption is 2.76 mA. An output buffer was designed to match a 50 Ω load and its current consumption is 5.5 mA. The technology used...
متن کاملA Low Noise Cascode Amplifier
A low noise amplifier has been designed using a 2SK117 N channel J-FET as the input device in a cascode [1] configuration. Noise measurements on this amplifier yield a low frequency noise current of 0.25 fA/Yfu and a voltage noise of less than 1.2 n V NHz in the 500 Hz to 50 kHz region. Bloyet et al. [2] suggest a figure of merit of the product of the noise voltage and current as being appropri...
متن کاملCMOS Low Noise Amplifier Design Optimization Techniques
This paper reviews and analyzes four reported low noise amplifier (LNA) design techniques applied to the cascode topology based on CMOS technology: classical noise matching (CNM), simultaneous noise and input matching (SNIM), powerconstrained noise optimization (PCNO), and power-constrained simultaneous noise and input matching (PCSNIM) techniques. Very simple and insightful sets of noise param...
متن کاملAdjustable Gain Cascode Low Noise Amplifier
Tower mounted amplifiers (TMA) serve to lower the system noise figure (NF) in cellular base-stations. For performance reasons, the TMA is located as near to the receiving aerial as practical and has to be connected to the rest of the radio at the tower’s base by a long run of coaxial cable. The parameters critical to TMA performance are low NF for reasons of optimizing coverage area, high gain ...
متن کاملA Reconfigurable CMOS Low Noise Amplifier for Wireless LAN Applications
This paper presents the designed and implemented CMOS Low Noise Amplifier (LNA) for multiband operation in TSMC 0.18 m process. To operate in multibands and multistandards, switched inductor and switched capacitor array are used in input and output signal paths. Due to filtering characteristic of input stage, the LNA can suppress spurious signal effectively. The designed reconfigurable LNA is t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nano-and electronic Physics
سال: 2022
ISSN: ['2306-4277', '2077-6772']
DOI: https://doi.org/10.21272/jnep.14(3).03020