Cluster synchronization transmission of laser pattern signal in laser network with ring cavity
نویسندگان
چکیده
منابع مشابه
Alignement of a ring cavity laser
This manual describes a procedure to align the cavity of our Ti:Sapphire ring laser and its injection with an Argon-Ion pump laser beam. The setup is shown in figure 1. An 8W Argon-Ion pump beam is adjusted in size and degree of divergence by a telescope consisting of a 62mm and an 88mm lens (L1 and L2). A periscope (mirrors P1 and P2) and a collimation lens C (f=175 mm) is used to inject the 5...
متن کاملPerformance Modeling of Ring Laser Gyro in Inertial
In this paper, the performance of a Ring Laser Gyro based inertial navigation is investigated. Dynamic and stochastic modeling are applied to gyro simulation and performance evaluation. In the dynamic model, some parameters such as scale factor and environmental sensitivity have been determined, whereas in the stochastic model, the other parameters such as random drift and measurement noise...
متن کاملring-down spectroscopy with laser-current-tuned cavity resonance
High-precision analysis of the 17O / 16O isotope ratio in water and water vapor is of interest in hydrological, paleoclimate, and atmospheric science applications. Of specific interest is the parameter 17Oexcess (117O), a measure of the deviation from a linear relationship between 17O / 16O and 18O / 16O ratios. Conventional analyses of 117O of water are obtained by fluorination of H2O to O2 th...
متن کاملTunable External Cavity Ring Laser with Wavelength Selective Elements
The main objective of this study is to develop a near-infrared (NIR) tunable external cavity laser (ECL) that is based on a semiconductor optical amplifier and two different wavelength selective elements. In order to achieve the wavelength selection, several filters have been tested in the ECL setups, including plasmonic filter, acoustooptic tunable filter (AOTF), gradient photonic crystal and ...
متن کاملComposite Cavity Fiber Laser with Asymmetric Output Intensity and Wavelength
The composite cavity fiber laser (CCFL) is relatively simple in its fabrication, as it is essentially three wavelength matched Bragg gratings in a section of doped fiber. By using internal feedback with unequal sub-cavity lengths, unidirectional CCFLs with significantly asymmetric output power from its two outputs can be achieved. Preliminary results also show that it is possible for the lasing...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SCIENTIA SINICA Physica, Mechanica & Astronomica
سال: 2017
ISSN: 1674-7275
DOI: 10.1360/sspma2017-00022