Closure to “Discussion of ‘Film Boiling on Horizontal Cylinders in Helium II’” (1971, ASME J. Heat Transfer, 93, p. 18)

Heat Transfer Efficiency of Turbulent Film Boiling on a Horizontal Elliptical Tube with External Flowing Liquid

Film boiling on a horizontal elliptical tube immersed in external flowing nitrogen liquid is investigated in the present paper. The isothermal wall temperature is high enough to induce turbulent film boiling, and then a continuous vapor film runs upward over the surface. The high velocity of the flowing saturated liquid at the boundary layer is determined by potential flow theory. In addition, ...

Closure to “Discussion of ‘Factors of Safety for Richardson Extrapolation’ ” (2011, ASME J. Fluids Eng., 133, p. 115501)

The Technical Brief by Roache [1] presents ten items of discussion of our factor of safety (FS) method for solution verification [2]. Our responses are listed below item-by-item using the same numbering as Roache. The nomenclature mostly follows our own and not Roache’s such as pRE for the order of accuracy calculated using the Richardson Extrapolation as opposed to the observed order of conver...

Saturated Flow Boiling Heat Transfer in Horizontal Square Tube

Numerical Investigation on Slot air Jet impingement Heat Transfer between Horizontal Concentric Circular Cylinders

A numerical study has been carried out for slot air jet impingement cooling of horizontal concentric circular cylinders. The slot air jet is situated at the symmetry line of a horizontal cylinder along the gravity vector and impinges on the bottom of the outer cylinder which is designated as θ=0°. The outer cylinder is partially opened at the top with a width of W=30mm and is kept at constant t...

Natural Convection Heat Transfer from two Horizontal Cylinders

Natural convection heat transfer from a single horizontal cylinder and a pair of vertically aligned horizontal cylinders is investigated. Surface heat transfer distributions around the circumference of the cylinders are presented for Rayleigh numbers of 2 x 10, 4 x 10 and 6 x 10 and a range of cylinder spacings of 1.5, 2 and 3 diameters. With a cylinder pairing the lower cylinder is unaffected ...