Closed loop control of aerodynamic load fluctuations on wind turbine airfoil using surface plasma actuators

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Wind Turbine Aerodynamic Load Fluctuations using Model Based Iterative Learning Control

Control of aerodynamic loads in wind turbines is a critical issue in terms of keeping them economically competitive with alternative energy sources. This paper continues the investigation of the use of Iterative Learning Control (ILC) for load control in wind turbines with smart devices on rotor blades. Smart devices controlled by ILC are used to modify the blade section aerodynamics such that ...

متن کامل

Closed-Loop Control Wind Tunnel Tests on an Adaptive Wind Turbine Blade for Load Reduction

Wind tunnel tests on a non-rotating, dynamically scaled wind turbine blade equipped with variable trailing edge geometry were carried out. The effectiveness of the system for active load reduction purposes, with the interaction between structural dynamics, aerodynamics and control was tested. The actuation of the adaptive trailing edge was based on a piezoelectric bender actuator. The full aero...

متن کامل

Aerodynamic Optimal Design of Wind Turbine Blades using Genetic Algorithm

Wind power has been widely considered and utilized in recent years as one of the most promising renewable energy sources. In the current research study, aerodynamic analysis of the upwind three-bladed horizontal axis turbine is carried out using blade element momentum theory (BEM), and a genetic algorithm (GA) is applied as an optimization method. Output power generation is considered as an obj...

متن کامل

Aerodynamic Control Using Windward-Surface Plasma Actuators on a Separation Ramp

Wind-tunnel experimentswere conducted on a 47-deg sweep, scaled 1303unmanned air vehiclemodel to assess the performance of an innovative windward-surface plasma actuator design for flight control at low angles of attack. Control was implemented by altering the flow past an aft separation ramp on the windward side using a single dielectric barrier discharge plasma actuator. The influence of ramp...

متن کامل

Aerodynamic optimal design of wind turbine blades using genetic algorithm

Wind power has been widely considered and utilized in recent years as one of the most promising renewable energy sources. In the current research study, aerodynamic analysis of the upwind three-bladed horizontal axis turbine is carried out using blade element momentum theory (BEM), and a genetic algorithm (GA) is applied as an optimization method. Output power generation is considered as an...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: IFAC-PapersOnLine

سال: 2020

ISSN: 2405-8963

DOI: 10.1016/j.ifacol.2020.12.1848