Clay-Filled Polyelectrolyte Complex Nanocoating for Flame-Retardant Polyurethane Foam
نویسندگان
چکیده
منابع مشابه
Clay-chitosan nanobrick walls: completely renewable gas barrier and flame-retardant nanocoatings.
Thin films prepared via a layer-by-layer (LbL) assembly of renewable materials exhibit exceptional oxygen barrier and flame-retardant properties. Positively charged chitosan (CH), at two different pH levels (pH 3 and pH 6), was paired with anionic montmorillonite (MMT) clay nanoplatelets. Thin-film assemblies prepared with CH at high pH are thicker, because if the low polymer charge density. A ...
متن کاملHypophosphite/Graphitic Carbon Nitride Hybrids: Preparation and Flame-Retardant Application in Thermoplastic Polyurethane
A series of aluminum hypophosphite (AHPi)/graphite-like carbon nitride (g-C₃N₄) (designated as CAHPi) hybrids were prepared, followed by incorporation into thermoplastic polyurethane (TPU). The introduction of CAHPi hybrids into TPU led to a marked reduction in the peak of the heat release rate (pHRR), total heat release, weight loss rate, smoke production rate and total smoke production (TSP)....
متن کاملResults from Screening Polyurethane Foam Based Consumer Products for Flame Retardant Chemicals: Assessing Impacts on the Change in the Furniture Flammability Standards
Flame retardant (FR) chemicals have often been added to polyurethane foam to meet required state and federal flammability standards. However, some FRs (e.g., PBDEs and TDCIPP) are associated with health hazards and are now restricted from use in some regions. In addition, California's residential furniture flammability standard (TB-117) has undergone significant amendments over the past few yea...
متن کاملMulti-response Optimization of Grooved Circular Tubes Filled with Polyurethane Foam as Energy Absorber
The main objective of this research is to improvethe design and performance of the polyurethane foam-filled thin-walled aluminum grooved circular tubes using multi-response optimization (MRO) technique. The tubes are shaped with the inner and the outer circular grooves at different positions along the axis. For this aim, several numerical simulations using ABAQUS finite element explicit code ar...
متن کاملAnisotropic polyurethane foam
Anisotropic polymer foams have been prepared, which exhibit a Poisson's ratio exceeding 1, and ratios of longitudinal to transverse stiffness exceeding 50. The foams are as much as 20 times stiffer in the longitudinal direction than the foams from which they were derived. The transformation process involved applying a uniaxial stress sufficient to produce 25% to 45% axial strain to open-cell po...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ACS Omega
سال: 2021
ISSN: 2470-1343,2470-1343
DOI: 10.1021/acsomega.0c05354