Chromium Deposition on Cobalt-Based Alloys by Pack-Cementation and Behaviour of the Coated Alloys in High Temperature Oxidation
نویسندگان
چکیده
منابع مشابه
Chromium Deposition on Cobalt-Based Alloys by Pack-Cementation and Behaviour of the Coated Alloys in High Temperature Oxidation
Two TaC-strengthened cobalt-based alloys, with compositions Co-10Cr-0.25C-4.4Ta and Co-10Cr-0.5C-8.7Ta (wt.%) underwent Cr-deposition by pack-cementation, followed by heat-treatment to allow Cr diffusing deeper in their sub-surface. Thereafter they were tested for 50 hours at 1200°C in a thermobalance. These alloys were successfully enriched in chromium, with a maximal content on surface of abo...
متن کاملHigh Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration
High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...
متن کاملThermogravimetric Study of Oxide Spallation for Chromium-Rich Cast Cobalt-Based and Iron-Based Alloys Oxidized at High Temperature
During temperature cycles, metallic alloys for high temperature applications are usually oxidized with formation of an external protective oxide scale, but they loose it during the cooling. This problem of oxide spallation can be studied by specific tests of cyclic oxidation but first indications can be provided by analyzing the cooling parts of thermogravimetry curves. This possibility was stu...
متن کاملOxidation Start Detection on Heating Parts of Thermogravimetry Curves for High Temperature Alloys Based on Nickel, Cobalt or Iron
The heating parts of thermogravimetry curves performed for cast alloys in air at high temperatures were analysed, after correction from the effects of air buoyancy variation, to characterize the transient oxidation before reaching the targeted temperature for the isothermal stage usually applied thereafter. This was done here for three binary M-30Cr alloys, six ternary M-30Cr-0.4 and 0.8%C allo...
متن کاملCobalt-chromium alloys in fixed prosthodontics in Sweden
Aim: The aim of this study was to compile the usage of Co-Cr alloys in fixed prosthodontics (FP) among dental laboratories in Sweden. Methods: From March to October 2015, questionnaires were sent to 542 registered dental laboratories in Sweden. The questionnaires were divided in two parts, one for fixed dental-supported prosthodontics (FDP) and one for fixed implant-supported prosthodontics (FI...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Open Corrosion Journal
سال: 2011
ISSN: 1876-5033
DOI: 10.2174/1876503301104010027