Chemistry of intermediate layer water-oil emulsion formation
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Modeling Water-in-Oil Emulsion Formation Using Fuzzy Logic
Yildiz Technical University, Faculty of Civil Engineering, Department of Environmental Engineering, 34220 Davutpasa, Esenler, Istanbul, Turkey Tel.: +90 212 383 5376, Fax: +90 212 383 5358 E-mail: [email protected]; [email protected] Spill Science, 1717 Rutherford Point, S.W. Edmonton, Alberta, Canada T6W 1J6 Tel.: 780 989 6059, Fax: 780 433 6444 E-mail: [email protected] (Merv Finga...
متن کاملCombustion of Water-in-Oil Emulsion Layers Supported on Water
In situ combustion of a water-in-oil emulsion layer supported on water is a complex process. In this paper, the combustion process of water-in-oil emulsion layers floating on top of a water body, as in the case of in situ burning of oil spilled at sea that has turned into emulsion, is modeled by using comprehensive mathematical treatment, and the results are compared with data obtained in our l...
متن کاملInvestigation of the film formation mechanism of oil-in-water (O/W) emulsion
To reveal the film formation mechanism of oil-in-water (O/W) emulsion, nanofilms of aqueous paraffin oil emulsion stabilized with the nonionic Tween 80 and Span 80 surfactants were measured in confinement between two solid surfaces, by the use of relative optical interference intensity (ROII) approach. In contrast to single-phase oil lubricant, the film formation of oil-in-water emulsions norma...
متن کاملSpreading of an Oil-in-Water Emulsion on a Glass Plate: Phase Inversion and Pattern Formation.
Rigid blade coating of glass plates by oil-in-water emulsions stabilized by surfactants is studied. Complete surface coverage is obtained only for speeds exceeding a threshold velocity dependent on the height between the blade end and the surface. Below this threshold, the emulsion can be inverted in the vicinity of the blade. The inversion dynamics of the oil-in-water emulsion and the depositi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2019
ISSN: 1757-899X
DOI: 10.1088/1757-899x/537/6/062059