منابع مشابه
Modification of the Surface Topography and Composition of Ultrafine and Coarse Grained Titanium by Chemical Etching
In this study, we present the detailed investigation of the influence of the etching medium (acidic or basic Piranha solutions) and the etching time on the morphology and surface relief of ultrafine grained (UFG) and coarse grained (CG) titanium. The surface relief and morphology have been studied by means of scanning electron microscopy (SEM), atomic force microscopy (AFM), and the spectral el...
متن کاملChemical etching of nitinol stents.
At present the main cause of death originates from cardiovascular diseases. Primarily the most frequent cause is vessel closing thus resulting in tissue damage. The stent can help to avoid this. It expands the narrowed vessel section and allows free blood flow. The good surface quality of stents is important. It also must have adequate mechanical characteristics or else it can be damaged which ...
متن کاملAcid etching of titanium for bonding with veneering composite resins.
Commercially pure titanium (cpTi) was etched using three concentrated acids: 18% HCl, 43% H3PO4, and 48% H2SO4. The bond strengths between five types of veneering composite resin and eight cpTi treatments (involving combinations of sandblasting, acid etching in 48% H2SO4, and vacuum firing) were determined before and after 10,000 and 20,000 thermal cycles. There were no significant differences ...
متن کاملChemistry of titanium dry etching in fluorinated and chlorinated gases
native stoichiometric oxide, TiO2, always present on the titanium surface, results in a non-reproducible induction time. During etching the surface of titanium is covered by a highly fluorinated layer which protects the metal by the reaction with oxygen. Chlorine is not able to remove the native oxide unless drastic conditions are realized, Once this layer is removed with fluorine, the reaction...
متن کاملInductively Coupled Plasma Etching of Bulk Titanium for MEMS Applications
Titanium is a promising new material system for the bulk micromachining of microelectromechanical MEMS devices. Titaniumbased MEMS have the potential to be used for a number of applications, including those which require high fracture toughness or biocompatibility. The bulk titanium etch rate, TiO2 mask etch rate, and surface roughness in an inductively coupled plasma ICP as a function of vario...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Periodica Polytechnica Mechanical Engineering
سال: 2013
ISSN: 0324-6051,1587-379X
DOI: 10.3311/ppme.7046