Chatter Behavior in the Milling Process of Inconel 718: Effects of Tool Edge Radius
نویسندگان
چکیده
منابع مشابه
Experimental investigation of the gyroscopic and rotary inertia effects on the chatter boundary in a milling process
Experimental examination of the gyroscopic and rotary inertia effects on the chatter boundary in a milling operation is the chief aim of this article. The equations of motion of the tool vibration are derived based on Timoshenko beam theory and Hamilton principle by considering gyroscopic moment, rotary inertia, velocity-dependent process damping and radial immersion effect. For a range of dept...
متن کاملEvaluation of Tool Performance With Nanocrystalline Multilayer Coatings on the Machinability of Superalloy Inconel 718
In this paper, the performance of the cutting tool with nanocrystalline multilayer coatings (TiN+TiAlN) for machining of superalloy Inconel 718 in the dry and wet conditions was studied. The multi layer TiN and TiAlN with nanocrystalline structure was applied by physical vapor deposition technique (arc evaporation) on the WC-Co inserts. The results of the ball on disc wear test and the machinin...
متن کاملAn Application of Computational Intelligence Technique for Predicting Surface Roughness in End Milling of Inconel-718
In this paper, an attempt has been made to design an computational intelligence technique based expert system using Adaptive Neuro-Fuzzy Inference System (ANFIS) for predicting surface roughness in end milling of Inconel 718. Two different types of membership functions are adopted for analysis in ANFIS training and compared their differences regarding the accuracy rate of the surface roughness ...
متن کاملthe effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
Microstructure-sensitive flow stress modeling for force prediction in laser assisted milling of Inconel 718
Inconel 718 is a typical hard-to-machine material that requires thermally enhanced machining technology such as laser-assisted milling. Based upon finite element analysis, this study simulates the forces in the laser-assisted milling process of Inconel 718 considering the effects of grain growth due to c0 and c00 phases. The c0 0 phase is unstable and becomes the d phase, which is likely to pre...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2018
ISSN: 2261-236X
DOI: 10.1051/matecconf/201820202006