Charging Mechanism of Tl-2223 Superconducting Oxide Particles in Electrophoretic Deposition Bath.
نویسندگان
چکیده
منابع مشابه
Electronic Raman scattering of Tl-2223 and the symmetry of the ̋superconducting gap
Single crystalline Tl2Ba2Ca2Cu3O10 was studied using electronic Raman scattering. The ̋renormalization of the scattering continuum was investigated as a function of the scattering geometry to determine the superconducting energy gap 2∆( $ ) k . The A1gand B2g-symmetry component show a linear frequency behavior of the scattering intensity with a peak related to the energy gap, while the B1g-symme...
متن کاملElectrophoretic Deposition of Hydroxyapatite
The purpose of this study was to investigate the deposition of the hydroxyapatite (HA) coating via the electrophoresis procedure. The HA deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. Methanol was found to be the best deposition media. Among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pr...
متن کاملelectrophoretic deposition of hydroxyapatite
the purpose of this study was to investigate the deposition of the hydroxyapatite (ha) coating via the electrophoresis procedure. the ha deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. methanol was found to be the best deposition media. among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pressur...
متن کاملElectrophoretic deposition of MnCr2O4 coating for solid oxide fuel cell metallic interconnects
In the present study, Mn - Cr spinel powder was synthesized through a solid state reaction. In the next step, the electrophoretic deposition (EPD) method was used to apply the MnCr2O4 spinel, as an oxidation-resistant layer, on SUS 430 stainless steel in a potential of 300 V/cm. The coated and uncoated samples were then pre-sintered in air at 900 °C for 3 h followed by cyclic oxidation at 800 °...
متن کاملElectrophoretic deposition of biomaterials.
Electrophoretic deposition (EPD) is attracting increasing attention as an effective technique for the processing of biomaterials, specifically bioactive coatings and biomedical nanostructures. The well-known advantages of EPD for the production of a wide range of microstructures and nanostructures as well as unique and complex material combinations are being exploited, starting from well-disper...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2001
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.109.1268_294