Characterization of a NiTi SMA wire treated by nitrogen plasma based ion implantation (PBII)
نویسندگان
چکیده
منابع مشابه
Response of NiTi SMA wire electrically heated
In the present work an experimental-numerical approach is used to study the thermo-mechanical behaviour of NiTi wire for defining what parameters are the most important in actuator designing. Tests were carried out heating, by an electrical current, a wire having a diameter of 150 m, under constant stresses of 200 MPa. Data concerning strain, applied current and voltage are acquired during the ...
متن کاملDiagnostic characterization of ablation plasma ion implantation
Experiments are reported in which two configurations for ablation-plasma-ion-implantation ~APII! are characterized by diagnostics and compared. The first configuration oriented the target parallel to the deposition substrate. This orientation yielded ion-beam-assisted deposition of thin films. A delay (.5 ms) between laser and high voltage was necessary for this geometry to avoid arcing between...
متن کاملCorrosion and wear-corrosion behavior of NiTi modified by plasma source ion implantation.
The understanding of corrosion behavior in NiTi is critical for the devices using this shape-memory alloy. In order to improve the surface properties of NiTi such as corrosion resistance, plasma source ion implantation (PSII) technique was employed with oxygen as incident ions at three levels of implantation dose (5x10(16), 1x10(17) and 3x10(17) ions/cm(-2)). Pitting corrosion and wear-corrosio...
متن کاملPlasma-based ion implantation utilising a cathodic arc plasma
Plasma-based ion implantation (PBII) is usually carried out with isotropic gaseous plasmas, such as a discharge in nitrogen. More recently, it has been applied using drifting plasmas, such as those produced by cathodic arcs, in order to allow efficient implantation of metallic species. The condensable nature of a cathodic arc plasma allows for the deposition of ion-stitched thin film coatings, ...
متن کاملNonlinear Analysis of a Flexible Beam Actuated by a Couple of Active SMA Wire Actuators
There are two different ways of using SMA wires as actuators for shape control of flexible structures; which can be either embedded within the composite laminate or externally attached to the structure. Since the actuator can be placed at different offset distances from the beam, external actuators produce more bending moment and, consequently, considerable shape changes with the same magnitude...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2016
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2016.06.183