Characterization and Gas-sensing Performance of Spray Pyrolysed In2O3Thin Films: Substrate Temperature Effect

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Characterization of Spray Pyrolysed CuInS2 Thin Films

An indigenously developed chemical spray pyrolysis system was used to deposit polycrystalline CuInS2 thin films. It was found that smaller spray rate results in films with better crystallinity and lower resistivity. Increase in surface roughness of the films was observed for higher spray rates. Variations in film stoichiometry with composition of spray solution were analyzed along with its opto...

متن کامل

Fabrication, characterization and investigation of gas sensing properties of MoO3 thin films

In this research, molybdenum oxide (α-MoO3) thin films were coated on glass substrates using spray pyrolysis technique. 0.05 M ammonium heptamolybdate tetrahydrate was used as precursor and deionized water as solvent. The effects of carrier gas pressure, during the spraying of the solution, on the structural, optical, morphological and gas sensing properties of thin films were studied. X-ray di...

متن کامل

PREPARATION OF MoO3 THIN FILMS BY SPRAY PYROLYSIS AND ITS GAS SENSING PERFORMANCE

MoO3 thin films have been prepared by a simple spray pyrolysis technique at substrate temperature 250C. The structure and morphology of thin films are characterized by X-ray powder diffraction (XRD), scanning electron microscopy and UV-vis spectroscopy. The gas sensing properties of MoO3 thin film is studied at gas concentration 400 ppm and working temperature of 100–400 C. It was found that th...

متن کامل

SYNTHESIS, CHARACTERIZATION AND GAS SENSING PERFORMANCE OF SOL-GEL PREPARED NANOCRYSTALLINE SnO2 THIN FILMS

Nanocrystalline SnO2 thin films were successfully prepared using sol-gel dip coating technique. The starting precursor was used as tin chloride dihydrate (SnCl2.2H2O), ethanol and glycerin. As the prepared films were fired at 500 o C. These films were characterized using XRD, FESEM and TEM to known crystal structure, surface morphology and microstructure property. Elemental composition was stud...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Transactions on Electrical and Electronic Materials

سال: 2012

ISSN: 1229-7607

DOI: 10.4313/teem.2012.13.3.111