Characterization Alloys of the Sn-Zn System Produced by Melt Spinning
نویسندگان
چکیده
منابع مشابه
The Enthalpies of Mixing of Liquid Ni-Sn-Zn Alloys
The partial and integral enthalpies of mixing of liquid ternary Ni-Sn-Zn alloys were determined. The system was investigated along two sections xNi/xSn ≈ 1:9, xNi/xSn ≈ 1:6 at 1073 K and along two sections xSn/xZn ≈ 9:1, xSn/xZn ≈ 4:1 at 873 K. The integral enthalpy of mixing at each temperature is described using the Redlich-Kister-Muggianu model for substitutional ternary solutions. In additi...
متن کاملContribution to the knowledge of the Cu–Sn–Zn system for compositions close to brass alloys
The effect of tin content in the equilibrium phases of the Cu–Zn-based alloys, within the range of chemical compositions with interest to brass producers is described. For this purpose, ternary alloys with copper contents between 55.4 and 67.5 wt.% and tin contents up to 5.30 wt.% have been studied. The chemical composition of each alloy has been determined by X-ray fluorescence spectrometry (X...
متن کاملDevelopment of Sn-Zn-Al Lead-Free Solder Alloys
Fujitsu has implemented a company-wide effort to progressively reduce the use of lead (Pb) and eventually eliminate this environmental pollutant from its products. As part of this effort, we have developed a new lead-free solder that consists of tin (Sn), zinc (Zn), and aluminum (Al) and yet offers superior productivity and joint reliability. The new lead-free solder has a melting point equival...
متن کاملBandgap tunability in Zn(Sn,Ge)N(2) semiconductor alloys.
ZnSn1-x Gex N2 direct bandgap semiconductor alloys, with a crystal structure and electronic structure similar to InGaN, are earth-abundant alternatives for efficient, high-quality optoelectronic devices and solar-energy conversion. The bandgap is tunable almost monotonically from 2 eV (ZnSnN2 ) to 3.1 eV (ZnGeN2 ) by control of the Sn/Ge ratio.
متن کاملThermal Stability of P-Type BiSbTe Alloys Prepared by Melt Spinning and Rapid Sintering
P-type BiSbTe alloys have been widely implemented in waste heat recovery from low-grade heat sources below 600 K, which may involve assorted environments and conditions, such as long-term service, high-temperature exposure (generally 473-573 K) and mechanical forces. It is important to evaluate the service performance of these materials in order to prevent possible failures in advance and exten...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Research
سال: 2019
ISSN: 1980-5373,1516-1439
DOI: 10.1590/1980-5373-mr-2019-0144