Characteristics Study of the Insulator Polycarbonate Metal-Polymer-Semiconductor Device
نویسندگان
چکیده
منابع مشابه
Metal-Insulator-Semiconductor Photodetectors
The major radiation of the sun can be roughly divided into three regions: ultraviolet, visible, and infrared light. Detection in these three regions is important to human beings. The metal-insulator-semiconductor photodetector, with a simpler process than the pn-junction photodetector and a lower dark current than the MSM photodetector, has been developed for light detection in these three regi...
متن کاملNanoindentation characteristics on polycarbonate polymer film
The nanoindentation experiment was carried out to estimate nanomechanical characteristics of polycarbonate polymer films. Hardness, effective elastic modulus and contact stress–strain rate curve were obtained. The results showed that the effective elastic modulus and the hardness decreased as the applied load was increased. As the hold time was increased, the effective elastic modulus and the h...
متن کاملMetal–insulator–semiconductor electrostatics of carbon nanotubes
Carbon nanotube metal–insulator–semiconductor capacitors are examined theoretically. For the densely packed array of nanotubes on a planar insulator, the capacitance per tube is reduced due to the screening of the charge on the gate plane by the neighboring nanotubes. In contrast to the silicon metal–oxide–semiconductor capacitors, the calculated C – V curves reflect the local peaks of the one-...
متن کاملMetal-insulator transition in a doped semiconductor
Millikelvin measurements of the conductivity as a function of donor density and uniaxial stress in bulk samples of phosphorus-doped silicon establish that the transition from metal to insulator is continuous, but sharper than predicted by scaling theories of localization. The divergence of the dielectric susceptibility as the transition is approached from below also points out problems in curre...
متن کاملDevice-Level Simulation of Wave Propagation Along Metal–Insulator–Semiconductor Interconnects
A device-level simulation is presented for studying wave propagation along metal–insulator–semiconductor interconnects. A set of nonlinear equations is first formulated by combining the motion equations of charged carriers and Maxwell’s equations. The set of nonlinear equations is then transformed into the frequency domain, which leads to sets of nonlinear equations for the fundamental mode and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Rafidain Journal of Science
سال: 2005
ISSN: 2664-2786
DOI: 10.33899/rjs.2005.41552