Characteristics, Performance of Blend CA/SPEEK Ultrafiltration Membranes Prepared by Phase Inversion Method using PEG 600 as an Additive
نویسندگان
چکیده
منابع مشابه
Fabrication of Nanofiltration Membrane from Polysulfone Ultrafiltration Membrane Via Photo olymerization
UV-induced grafting technique was used as a flexible method for surface modification of Polysulfone (PSf) ultrafiltration (UF) membranes in order to prepare hydrophilic nanofiltration (NF) membranes. Flat sheet Polysulfone (PSf) ultrafiltration membranes were prepared via phase inversion method. N-methylene-2-pyrrolidone (NMP) and polyethylene glycol (PEG) of three different molecular weights (...
متن کاملPoly(vinylbenzylchloride) Based Anion-Exchange Blend Membranes (AEBMs): Influence of PEG Additive on Conductivity and Stability
In view of the many possible applications such as fuel cells and electrolysers, recent interest in novel anion exchange membranes (AEMs) has increased significantly. However, their low conductivity and chemical stability limits their current suitability. In this study, the synthesis and characterization of several three- and four-component anion exchange blend membranes (AEBMs) is described, wh...
متن کاملPreparation and Characterization of CA−PEG−TiO2 Membranes: Effect of PEG and TiO2 on Morphology, Flux and Fouling Performance
Modified cellulose acetate (CA) membranes were prepared by dissolving the polymers in a mixture of acetone (AC) and N, N dimethylacetamide (DMAc) (70:30) solvent and deionized (DI) water was used in the coagulation bath. The introduction of polyethylene glycol (PEG) additive and TiO2 nanoparticles (NPs) into the casting solution has changed the structures of the resulting membranes during the p...
متن کاملPreparation of blend hydrophilic PSF-SPEEK ultrafiltration membranes for oily wastewater treatment
Membrane separation is known as an efficient technique for the oily wastewater treatment. Therefore, in the present study, sulfonated poly (ether ether ketone) (SPEEK) was introduced into the polysulfone (PSF) solution in order to enhance the hydrophilicity and the membrane structure for the oil–water separation. The hollow fiber membranes were fabricated via a phase-inversion process. The memb...
متن کاملAN INFLUENCE OF PHASE DEVELOPMENT ON MECHANICAL STRENGTH OF ALUMINA-COPPER JOINT PREPARED BY MOLYMn METHOD
Abstract: The effect of phase development on peel strength of alumina-copper metalized joint has been investigated. The alumina-copper joint was prepared in three stages. The alumina substrate was, first, metalized at 1500°C in H2-furnace by a new formulation. In the second step, a nickel layer was electroplated on the metalized layer with approximately 10µm thickness. Finally, copper strip...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Membrane Science & Technology
سال: 2017
ISSN: 2600-9226
DOI: 10.11113/amst.v10i1.68