Characteristics of the Radio-Frequency/Vacuum Drying of Heavy Timbers for Post and Beam of Korean Style Housings Part II : For Korean red pine heavy timbers with 250 × 250 mm, 300 × 300 mm in cross section and 300 mm in diameter, and 3,600 mm in length
نویسندگان
چکیده
منابع مشابه
New Particle Monitoring Strategies in UPW for 300 mm Fabs
Process failures caused by particles in Ultra Pure Water (UPW) are relatively infrequent events, but with the move to 300 mm wafers and 90 nm line widths, they can have significant financial impact. Most particle monitoring strategies in the past focused on the use of the mobile and inline high sensitivity 0.05 micron particle counters. This paper examines the opportunities to improve performan...
متن کاملProcessing and Characterization of 300 mm Argon-Annealed Wafers
High nitrogen doped 300 mm silicon wafers annealed in 100 % argon ambient were investigated whether modified pulling conditions will lead to improved slip behavior and homogeneous radial oxygen precipitation. It turned out that increasing of the cooling rate during crystal pulling is beneficial on these wafer defect parameters. The void morphology was investigated by TEM and oxygen precipitatio...
متن کاملAnode Layer Linear Ion Source for Roll-to-Roll Process from 300 mm to 1550 mm
Roll-to-roll (RTR) process requires a linear surface treatment source in various processes such as pre-treatment, etching, and deposition. For high speed and large width processes the linear source should have superior characteristics that can be applied to 100~300 m/mim process and large width treatment up to 2 m. Several linear surface treatment sources have been proposed to the RTR process. ...
متن کاملHigh-current Ion Implanter for 300-mm SIMOX Wafer Production
OVERVIEW: There is an increased demand for the production of nextgeneration super-high-speed and low-power-consumption CMOS (complementary metal-oxide semiconductor) devices using SOI (silicon on insulator). Major global device manufacturers are actively commercializing this product. In SOI technology, a device is fabricated in a silicon layer (SOI layer) formed on a BOX (buried oxide) film. Al...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Wood Science and Technology
سال: 2011
ISSN: 1017-0715
DOI: 10.5658/wood.2011.39.2.132