Characteristics of Laser Machining of MDF.

control of the optical properties of nanoparticles by laser fields

در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...

Machining Characteristics of Direct Laser Deposited Tungsten Carbide

Laser Machining of Graphene

Since Geim and Novoselov’s successful production of high quality graphene, its unique properties have found a number of applications. But graphene is not an exotic chemical compound; instead, it is a sheet of graphite, one atom think. Before 2008, the only way to produce graphene was through successive pealing of graphite with scotch tape until graphite flakes as thin as 1 atomic layer were lef...

Spatter Tracking in Laser Machining

In laser drilling, an assist gas is often used to remove material from the drilling point. In order to design assist gas nozzles to minimize spatter formation, measurements of spatter trajectories are required. We apply computer vision methods to measure the 3D trajectories of spatter particles in a laser cutting event using a stereo camera configuration. We also propose a novel method for cali...

Theoretical Studies of Electrical Characteristics of the Nitrogen Laser

A theoretical analysis of the circuits for a nitrogen laser driven by the Blumlein or capacitor charge transfer transmission line is given in detail. The electrical characteristics of the charge line for a special case of resonant charging are discussed and the effects of various parameters on voltage and current are investigated. By using MICRO-CAP software the transient behavior of the curren...