Characteristics of Carbon Ion Implantation and DLC Film Deposition on Co-Cr-Mo Alloy

Effect of bias voltage on structural and mechanical characteristics of diamond-like carbon thin film applied by ion beam deposition

This study, investigates the effect of bias voltage on structural changes of diamond-like carbon thin film created by ion beam deposition is investigated. For this purpose, the bias voltage in the values of 0 V, -50 V, -100 V and -150 V on the AA5083 aluminum alloy was considered. Raman spectroscopy was used to evaluate structural. Influence of the bias voltage on the thickness and roughness of...

CORROSION RESISTANCE OF Co-Cr-Mo ALLOY USED IN DENTISTRY ODPORNOŚĆ KOROZYJNA STOPU Co-Cr-Mo WYKORZYSTYWANEGO W STOMATOLOGII

The presented paper studies the effect of the casting technology on the corrosion resistance of Co-Cr-Mo alloy. The investigations were conducted on a commercial alloy with the brand name ARGELOY N.P SPECIAL (Co-Cr-Mo) produced by Argen as well as the same alloy melted and cast by the lost wax casting method performed by a dental technician. The corrosion behavior of the dental alloys in an art...

Influence of temperature on passive film properties on Ni–Cr–Mo Alloy

COMPARATIVE STUDY OF CYTOTOXICITY OF DIRECT METAL LASER SINTERED AND CAST Co-Cr-Mo DENTAL ALLOY

T. Puskar, Department of Dentistry, Medical Faculty, University of Novi Sad, Serbia. A. Lapcevic, D. Jevremovic, Clinic for Prosthodontics, School of Dentistry Pančevo, University Business Academy, Novi Sad, Serbia. S. Arandjelovic, S. Radulovic, Institute for Oncology and Radiology of Serbia, Belgrade, Serbia. I. Budak, Dj. Vukelic, Faculty of Technical Sciences, University of Novi Sad, Novi S...

Comparison of Dental Prostheses Cast and Sintered by SLM from Co-Cr-Mo-W Alloy

The article presents the results of a comparative analysis of the metal substructure for dental prosthesis made from a Co-Cr-Mo-W alloy by two techniques, i.e. precision investment casting and selective laser melting (SLM). It was found that the roughness of the raw surface of the SLM sinter is higher than the roughness of the cast surface, which is compensated by the process of blast cleaning ...