Characterisation of liquid oil from pyrolysis of waste tyre
نویسندگان
چکیده
منابع مشابه
Characterisation of products from pyrolysis of waste sludges
The pyrolysis of waste sludges was investigated using thermogravimetry/mass spectrometry (TG/MS) and a fixed-bed reactor. Two types of sludge were used, namely mixed sludge and oil sludge. In TGA/MS measurements, two degradation steps were observed. Degradation of organic structures, in sludge took place in the first step, while inorganic materials in sludge were mainly decomposed in a second s...
متن کاملThe use of tyre pyrolysis oil in diesel engines.
Tests have been carried out to evaluate the performance, emission, and combustion characteristics of a single cylinder direct injection diesel engine fueled with 10%, 30%, and 50% of tyre pyrolysis oil (TPO) blended with diesel fuel (DF). The TPO was derived from waste automobile tyres through vacuum pyrolysis. The combustion parameters such as heat release rate, cylinder peak pressure, and max...
متن کاملCatalytic Pyrolysis of Waste Tyre Rubber into Hydrocarbons Via Base Catalysts
The waste tyres represent a source of energy and valuable hydrocarbon products. Waste tyres were pyrolysed catalytically in a batch reactor under atmospheric pressure. The effects of basic catalysts (MgO and CaCO3) were studied on the pyrolysis products. The distribution ratio of gas, liquid and char with MgO and CaCO3 were 24.4:39.8:35.8 wt % and 32.5:32.2:35.2 wt % r...
متن کاملCatalytic Pyrolysis of Waste Tyre Rubber into Hydrocarbons Via Base Catalysts
The waste tyres represent a source of energy and valuable hydrocarbon products. Waste tyres were pyrolysed catalytically in a batch reactor under atmospheric pressure. The effects of basic catalysts (MgO and CaCO3) were studied on the pyrolysis products. The distribution ratio of gas, liquid and char with MgO and CaCO3 were 24.4:39.8:35.8 wt % and 32.5:32.2:35.2 wt % respectively at 350°C for 2...
متن کاملResearch on Emulsified Tyre Pyrolysis Oil as a Coal Flotation Collector
In this paper the possibility of using the pyrolysis oil derived from waste tyres as a collector in flotation of coal was evaluated. The pyrolysis oil was obtained at the initial and final pyrolysis temperatures of 400 and 700 C, respectively, and the heat holding time of 30 min. Flotation results indicated that the pyrolysis oil emulsion showed stronger collecting ability than diesel and the c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Malaysian Journal of Chemical Engineering and Technology (MJCET)
سال: 2020
ISSN: 2682-8588
DOI: 10.24191/mjcet.v3i1.11244