Changes in Flow Velocity and Metal Flow in Direct Extrusion of Aluminum Alloy
نویسندگان
چکیده
منابع مشابه
comparison of blood flow velocity changes in posterior cerebral artery measured with transcranial doppler sonography in migraineurs with visual aura and normal persons after photostimulation
چکیده ندارد.
15 صفحه اولFLOW BEHAVIOR OF MOLTEN METAL IN ALUMINUM LFC PROCESS
The effects of gating system and pattern geometry on the metal flow in the lost foam casting (LFC) process have been investigated using glass covered mold and video recording system. Unlike convectional casting process, the type of the gating system showed little effect on fillability in lost foam, but pattern thickness had large effect on mold filling. The mold filling behavior seems to be con...
متن کاملCoupled analysis of material flow and die deflection in direct aluminum extrusion
The design of extrusion dies depends on the experience of the designer. After the die has been manufactured, it is tested during an extrusion trial and machined several times until it works properly. The die is designed by a trial and error method which is an expensive process in terms of time and the amount of scrap. In order to decrease the time and the amount of scrap, research is going on t...
متن کاملthe effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
Investigation of the Forming Force in Torsion Extrusion Process of Aluminum Alloy 1050
In this paper, torsion extrusion (TE) process on 1050 aluminum alloy was investigated by simulation as a severe plastic deformation (SPD) method and the effects of friction coefficient, angular velocity of the rotating die and punch speed on maximum punch force were studied. A finite element (FE) model was developed to simulate the TE process via DEFORM software. The FE results were validated co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series A
سال: 2003
ISSN: 1344-7912,1347-5363
DOI: 10.1299/jsmea.46.237