Changes in Estimated Dislocation Density during Creep in Martensitic Heat-Resistant Steel
نویسندگان
چکیده
منابع مشابه
Precipitation behavior in a nitride-strengthened martensitic heat resistant steel during hot deformation
The stress relaxation curves for three different hot deformation processes in the temperature range of 750-1000 °C were studied to develop an understanding of the precipitation behavior in a nitride-strengthened martensitic heat resistant steel (Zhang et al., Mater. Sci. Eng. A, 2015) [1]. This data article provides supporting data and detailed information on how to accurately analysis the stre...
متن کاملLecture 14 : Creep – Resistant Steel , Case Study
Introduction Typical operating parameters for steels used in the manufacture of power plant are compared against corresponding values for nickel alloys in aeroengines, in Table 1. In both cases, the service conditions are severe. But this is especially so for steels where the service life is many decades. The degree of reliability demanded of heat resistant steels is therefore extraordinary, an...
متن کاملCreep and Fatigue Interaction Behavior in Sanicro 25 Heat Resistant Austenitic Stainless Steel
Sanicro 25 is a newly developed advanced high strength heat resistant austenitic stainless steel. The material shows good resistance to steam oxidation and flue gas corrosion, and has higher creep rupture strength than other austenitic stainless steels available today. It is thus an excellent candidate for superheaters and reheaters for advanced ultra-super critical power plants with efficiency...
متن کاملCreep Fracture in Tempered Martensitic Steels
Creep strength enhanced ferritic (CSEF) steels which contain 9 to 12%Cr have become the steels of choice in many industrial high energy systems. The typical compositions of alloy types P91, P92 and E911 are compared with 12CrMoV in Table 1. These steels are selected for use in applications where high temperature creep can occur because of a favorable balance between cost and properties [1,2]. T...
متن کاملData related to dislocation density-based constitutive modeling of the tensile behavior of lath martensitic press hardening steel
The data presented in this article are related to the research article entitled "On the plasticity mechanisms of lath martensitic steel" (Jo et al., 2017) [1]. The strain hardening behavior during tensile deformation of a lath martensitic press hardening steel was described using a dislocation density-based constitutive model. The Kubin-Estrin model was used to describe strain hardening of the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Science Research
سال: 2015
ISSN: 1927-0593,1927-0585
DOI: 10.5539/jmsr.v4n4p48