CFD Modelling of Pump as Turbine with Various Number of Blade for Microhydro System
نویسندگان
چکیده
منابع مشابه
Turbine Blade Cascade Heat Transfer Analysis Using CFD –A Review
Heat transfer analysis on a turbine blade cascade using CFD is reviewed in this paper based upon the literature available. The flow conditions across turbine blades are complex because of three dimensional configuration of the blade. Axial flow turbine blade design is hectic because understanding of control flows, prediction and analysis is a tedious task. The flow behaviour in a turbine blade ...
متن کاملSimulating Cooling Injection Effect of Trailing Edge of Gas Turbine Blade on Surface Mach Number Distribution of Blade
In this research, a gas turbine blade cascade was investigated. Flow analysis around the blade was conducted using RSM and RNG.K-ε turbulence modeling and it is simulated by Fluent software. The results were considered for the cases as Mach number loss at the trailing edge of blade caused by vortexes that were generated at the end of blade. Effect of cooling flow through the trailing edge on th...
متن کاملCFD Wake Modelling with a BEM Wind Turbine Sub-Model
Modelling of wind farms using computational fluid dynamics (CFD) resolving the flow field around each wind turbine’s blades on a moving computational grid is still too costly and time consuming in terms of computational capacity and effort. One strategy is to use sub-models for the wind turbines, and sub-grid models for turbulence production and dissipation to model the turbulent viscosity accu...
متن کاملOptimization of turbine blade cooling with the aim of overall turbine performance enhancement
In the current work, different methods for optimization of turbine blade internal cooling are investigated, to achieve higher cyclic efficiency and output power for a typical gas turbine. A simple two-dimensional model of C3X blade is simulated and validated with available experimental data. The optimization process is performed on this model with two different methods. The first method is ...
متن کاملOptimization of turbine blade cooling with the aim of overall turbine performance enhancement
In the current work, different methods for optimization of turbine blade internal cooling are investigated, to achieve higher cyclic efficiency and output power for a typical gas turbine. A simple two-dimensional model of C3X blade is simulated and validated with available experimental data. The optimization process is performed on this model with two different methods. The first method is ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Applied Science & Process Engineering
سال: 1970
ISSN: 2289-7771
DOI: 10.33736/jaspe.171.2016